Loading ...
Loading ...
Loading ...
Performance Data Sheet
SmartWaterFiltrationSystem
GWF/ HWFCartridge
Thissystemhasbeen testedaccordingtoNSF/ANS142/53for reductionofthesubstanceslistedbelow.
Theconcentrationoftheindicatedsubstancesin water enteringthesystemwas reducedtoa concentration
lessthanor equalto thepermissiblelimit for water leavingthesystem,as specified in NSF/ANSI#2/53.*
(100%safety factors built in for unmetered usage)
Parameter
Chlorine
T&O
Particulate**
USEPA
MCL
StaJidaxd No. 42: Aesthetic Effects
Iniluent EMuent
Challenge Concentration Average Maximum
2.0 mg/L +_10% 0.02 ppm 0.05 ppm
at least l!),()I)I) particles/mL 3,978 7,800
% Reduction
Average Minimum
98.90% 97.37%
98.00% 96.10%
Min. Required
Reduction
_>5O%
_>85%
Standard No. 53: Health Effects
Parameter Effluent
Average Maximum
Tmt)idity 0.07 NTU 0.1 NTU
C) sts 2(5 55
Lead at pH (5.5 1 ppb 1 ppb
Lead at pH 8.5 1.8 ppb 4.3 ppb
[Jndane 0.00005 ppm 0.00005 ppm
Atmzine 0J)02 ppm 0J)03 ppm
2,4-[) 0.042 ppm 0.090 ppm
Asbestos 0.32 MR./ml 1.2 MR./ml
USEPA
MCL
1 NTU***
99.95% Reduction
15 ppb
15 ppb
0.0002 ppm
0.003 ppm
0.100 ppm
99%
In fluent
Challenge Concentration
11 +_1 NTU***
Milailnum 50,000 I,
0.15 mg/I, _+10%
0.15 mg/I, _+10%
0.002 mg/I, _+10%
0.009 mg/I, _+10%
0.210 mg/I, _+10%
I(F to 10 _fibel_/L;
fibers gn'eater than
10 micrometel_ in length
% Reduction
Average Minimum
99.71% 99.59%
99.97% 99.95%
99.37% 99.37%
98.8% 97.13%
91.93% 91.93%
76.19% 64.28%
84.89% 67.63%
99.95% 99.82%
Min. Required
Reduction
O.5 NTU
> 99.95%
0.010 mg/I.
0.010 mg/I.
0.0002 mg/I.
0,003 mg/I.
0.07 mg/L
99%
Tested using a flow rote of 0.5 gpm; pressure of 60 psig; pH of 7.5 +_0.5; temp. of 20° +_2.5°C
** Measurement in Particles/ml. Particles used were 0.5-1 microns
*** NTU=Nephelometric Turbidity units
Operating Specifications
• Capacity: certified for up to 300 gallons (l 135 l); up to six months for models without a replacement filter indicator light; up
to one year for models with a replacement filter indicator light
• Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
• Temperature: 33-100°F (0.6-38°(;)
• Flow rate: 0.5 gpm (1.9 lpm)
General Installation/Operation/Maintenance Requirements
• Flush new cartridge at full flow for 3 minutes to purge ()tat trapped all
• Replace cartridge when flow becomes too slow.
Special Notices
• Installation instructions, parts and service availability, and standard warranty are included with the product when shipped.
• This drinking water system nlust be maintained according to manufacuner's insuuctions, including replacement of filter
cartridges.
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or
after the system. Systems cerdfied for cyst reduction may be used on disinfected water that m W contain filterable cysts.
• The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your
watei.
• Check for compliance with the state and local laws and regulations.
• Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Systems
must be installed and operated in accordance with manufacturer's recommended procedures and guidelines.
S)stem Tested and Certified by NSF International against ANSI/NSF Standard 42 & 53 fi>r
the reduction of:
Standard No. 42: Aesthetic Effects
Chemical L)nit
Taste and Odor Reduction
Chlorine Reduction
Mechanical Fihration Unit
Particulate Reduction, (;Mass I
Standard No. 53: Health Effects
Chemical Reduction Unit
Lead and Atrazine Reduction
[Jndane and 2,4-D Reduction
Mechanical Filtration Unit
Turbidit} Reduction
()st and Asbestos Reduction
Mantdi_ctured for: General Electric Company, [xmisville, KY 40225
34
Loading ...
Loading ...
Loading ...