Loading ...
23-3/4"
/----"J_overallwidth
DoubUe oven
22=3/8"raax,
recessed width
23"raax,
recessed
depth
49=1/2"
recessed
height
23=3/4"
width
j_
J
51" raax,
overall
height
/
27=3/4"
rain,
cutout
height
24" rain,
cabinet width
22=1/2"
cutout width
Single oven
undercounter
(without cooktop
installed above)
1=1/2"rain.
top ofcutout
to underside
of countertop
5=1/4" bottom of
cutout to floor
T
49=3/4"
rain.
cutout
height
1=1/2" rain,
bottom of
cutout to top of
cabinet door
24" rain,
"_--- cabinet -_"
22=1/2"
4-- cutout ---_
width
Doable oven
1" top ot cutout
to bottora of
upper cabinet
door
14=3/4"
bottora
of cutout
to floor
[
27=3/4"
rain.
cutout
height
1=I/2"
rain.
botteraef
cutoutto
top of
cabinet
door
24"rain,
_--cabinetwidth--
22=I/2"
_--- cutout ---_
width
l"topefcuteut
to botteraef
upper cabinet
door
32 _
bottom of
cutout to
floor
cabinet_---
23=l/4"rain.
cutout depth
23"recessed
even depth
recessed
oven
oven
/_ front
Singmeoven
Cabinet side view
Your safety and the safety of others are
very important,
We haveprovided many important safety
messagesinthis manualand onyour appliance.
Atways read and obeyaIIsafety messages.
This is the safety alertsymbol,
Thissymboi alertsyou to potential hazards
that cankiii or hurtyou andothers,
Ati safety'messageswiii foiiow the safetyalert
symbo! andeitherthe word "DANGER"or
"WARNING",Thesewords mean:
You canbekilledorseriouslyinjuredifyoudon't
follow instructions.
Ati safety messageswiii teii you what the potential
hazardis, toil you howto reducethe chanceof
injury, andteli you what can happenif the
instructions are not foiiowed.
important: Observe all governing codes
and ordinances.
Proper installation isyour responsibility.
Have a qualified technician install this oven.
Oven location should be away from strong draft
areas, such as windows, doors and strong
heating vents.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed portion
of the oven.
Electrica_ground is required. See "Electrical
requirements."
EJectrica_supply junction box should be located
3 inches maximum below the support surface
when oven is installed in a wall cabinet. Drill a
1°inch minimum diameter hole in the right rear
or left rear corner of the support surface to pass
the appliance cable through to the junction box.
For undercounter installation, it is recommended
that the junction box be located in the adjacent
right or left cabinet. If installing the junction box
on rear wall behind oven, junction box must be
recessed and located in the upper or lower right
or left corner of cabinet.
Oven support surface MUST be solid, level and
flush with bottom of cabinet cutout.
it is the customer's responsibility:
To contact aqualifiedelectrical installer.
To assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSl/NFPA 70 _ latest edition*,
and all local codes and ordinances.
Copies of the standards _isted may be obtained from:
* National Fire Protection Association
Batteryraarch Park
Quincy, Massachusetts 02269
Tool needed:
Z
screwdriver
Partssupplied:
4 screws (double oven)
Page 1
Loading ...
Loading ...
Loading ...