Loading ...
Loading ...
Loading ...
Zip HydroTap Installation and Operating Instructions - 89585 - March 2016 v2.03 Page 7 of 16
In addition to normal tools, the following will be required:
• 35mm diameter sheet metal hole punch for sink tops. (not supplied)
• 35mm diameter hole saw for timber bench tops. (not supplied)
• Nut runner tube spanner (supplied) for fixing tap assembly.
When installing a Font unit:
• 108mm diameter sheet metal or hole saw to suit surface being cut.
Special Tools Required
Step A - Installing the tap
1. Make sure that the tap location will allow the nozzle to drain into the sink.
2. Cut a 35mm hole in the bench / sink top.
3. Install the black plastic spacer to the base of the tap and ensure it remains
in place as this is the moisture seal against the bench / sink top. A light
smearing of silicon sealant on the underside of the spacer will ensure
a watertight fit.
4. Pass the hoses through the 35mm hole and carefully locate the Head
Assembly and black spacer on the bench / sink area.
5. From the underside of the bench / sink area re-locate the S/S washer and
“Spider Clamp” by feeding each of the tubes and electrical cable evenly in
between the legs of the “Spider Clamp”. Slide it up to meet the “All
Thread”, and pass the “All Thread” through the center of the “Spider
Clamp”.
6. Hold the “All Thread” steady and re-fit the 6mm nut to the “All Thread”
using the tube spanner supplied in the kit. Check the Tap Head position
before securing it tightly against the bench / sink top.
NOTE 1: The tap assembly must not be positioned more than 900mm
above the HydroTap unit.
Failure to do this may result in poor water delivery.
NOTE 2: Under no circumstances should the Tap be twisted after the
installation is complete.
Installation Procedure
Fixing nut Black spacer
Spider clamp Smear silicon
on underside
flat surface
Note: A stainless steel washer is
supplied to go in between the
Spider Clamp and the underside
of the sink top.
Black
Plastic
Spacer
See para 3.
Spider
Clamp
Fixing nut
S/S
Washer
Tap
All-thread rod
Benchtop
Loading ...
Loading ...
Loading ...