Ashley AP5660PE Heater

User Manual - Page 3

For AP5660PE.

PDF File Manual, 56 pages, Download pdf file

Loading ...
Loading ...
Specications
Heating Specications
Fuel Burn Rate* (lowest setting) 1.5 lbs./hr.
Hopper Capacity 60 lbs.
Dimensions
Height 37” (942 mm)
Width 24.25” (615.9 mm)
Depth 26.19” (665.2 mm)
Electrical Specications
Electrical Rating 115-120 volts, 60 HZ, 3.0 Amps
Watts (operational) 180W
Watts (igniter running) 346W
* Pellet size may effect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as
20%. Use PFI listed fuel for best results.
This manual describes the installation and operation of the Ashley, AP5660PE pellet stove. This heater meets the
2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood-heaters sold after May 15, 2020.
Under specic EPA test conditions burning Douglas Fir dimensional lumber this heater has been shown to deliver
heat at a rate of 11,155 to 24,361 btu/hr. This heater achieved a particulate emissions rate of 1.9 g/hr and an
efciency of 62%.
FUEL CONSIDERATIONS
Your pellet stove is designed and tested with premium grade pellets that comply with Pellet Fuels Institute (PFI)
standards. You can only burn premium grade pellets in this pellet heater (minimum of 40 lbs density per cubic
feet, 1/4” to 5/16” diameter, length no greater than 1.5”, not less than 8,200 BTU/lb, moisture under 8% by weight,
ash under 1% by weight, and salt under 300 parts per million). Pellets that are soft, contain excessive amounts
of loose sawdust, have been, or are wet, will result in reduced performance and may cause damage to your
heater. Store your pellets in a dry place. DO NOT store the fuel within the installation clearances of the unit or
within the space required for refuelling and ash removal. Doing so could result in a house re. Do not over-re or
use volatile fuels or combustibles, doing so may cause a personal and property damage hazards.
SAFETY AND EPA COMPLIANCE
Your pellet stove has been approved for installation in the USA and Canada. It may also be installed in a
manufactured or mobile home. Your stove is Certied to ASTM E1509-12 (2017), and Certied to ULC S627, 2000
WARNING: It is against federal regulations to operate this wood heater in a manner inconsistent with the
operating instructions in the owner’s manual.
-3-
Loading ...
Loading ...
Loading ...