Troy-Bilt TB575SS 4-Cycle Gasoline Trimmer

Operator's Manual - Page 5

For TB575SS. Also, The document are for others Troy-Bilt models: TB525CS

PDF File Manual, 22 pages, Read Online | Download pdf file

TB575SS photo
Loading ...
Loading ...
Loading ...
WARNING: Operate this unit only in a well-
ventilated outdoor area. Carbon monoxide exhaust
fumes can be lethal in a confined area.
WARNING: Avoid accidental starting. Make sure
you are in the starting position when pulling the
starter rope (Fig. 8). To avoid serious injuw, the
operator and unit must be in a stable position while
starting.
To avoid serious personal injuw, ensure any Add-
On being used is installed correctly and secure
before starting the unit.
STARTING INSTRUCTIONS
1, Check the oil level in the crankcase. Refer to
Checking the Oil Level.
2, Fill the fuel tank with fresh, clean unleaded gasoline.
Refer to Fueling the Unit,
3, Make sure the On/Off Stop Control in the ON ( I )
position (Fig. 6).
4, Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in
the primer bulb and fuel lines (Fig. 7). If you can't
see fuel in the bulb, press and release the bulb as
many times as it takes before you can see fuel in it.
5. Place the choke lever in Position 1 (Fig. 7).
6. Crouch in the starting position (Fig. 8). Squeeze the
throttle control lever. Pull the starter rope briskly 5
times.
7. Place the choke lever in Position 2 (Fig. 7).
8. While squeezing the throttle control, pull the starter
rope briskly 1to 4 times to start the engine.
9. Keep the throttle squeezed and allow the engine to
warm up for 15 to 30 seconds.
10. Place the choke lever in Position 3 (Fig. 7). The unit
is ready for use.
...............IF...The engine does not start, go back to step 4.
IF...The engine fails to start after a few attempts, place
the choke lever in Position 3 and squeeze the
throttle control. Pull the starter rope briskly 3 to 8
times. The engine should start. If not, repeat.
Stop/Off (O)
Start/On (I)
Throttle Control
Fig. 6
Choke Lever
Primer Bulb
Fig. 7
Starter Rope
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control. Allow the
engine to cool down by idling.
2. Press the On/Off Stop Control switch in the OFF (O)
position.
Throttle Control
Fig. 8
APPLICATIONS
As a trimmer:
Cutting grass and light weeds
Edging
Decorative trimming around trees, fences, etc.
Loading ...
Loading ...
Loading ...