Loading ...
Loading ...
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the
operator's manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
'SAFETyALERTSyMBOL
Indicates danger, warning or cautio n. MaY be used
n con unct on wth other symb0 s or p ctographs.
• WARNING ,READ OPERATOR'S MANUAL
Read the Operator's manual(s) and follow all warning s
and safety instructions. Failure to de SOcan result in
serious injury to the operate[ and/or bystanders,
• WEAR EYE AND HEARING PROTECTION
WARNING: Thrown objects and loud noise can
cause severe eye injury and hearing loss. Wear eye
protection meeting ANSI Z87.1 standards and ear
protection when operating th! s unit. Use a fuHface
HOTSU,FAOEWA,N,,G
De not touch a hot muffler, gear housing or cylinder.
you may get burned. These parts get extremely hot
_1_1, from operation. They remain hot for a short time after
the unit is turned 0ff.
N%' UNLEADED FUEL
_ Always use clean fresh unleaded fuel
' O!L ;
_7 _ Refer to Operator s manual for the propel type o!
oil.
SYMBOL
A
H lq I 'l
MEANING
• KEEP BYSTANDERS AWAY
WARNING: Keep all bystaneers, espectaHy
childrer and Pets. at least 50 feet (15 m) from the
operating area.
• CHOKE CONTROL
1. • FULL choke oosition
2. • PARTIAL choke position
3. • RUN choke position
• THROWN OBJECTS AND ROTATING CUTTER
CAN CAUSE SEVERE INJURY
WARNING: Do not operate without the cutting
attachment shield n elace. Keep away from me
Lting cutting attachmen]
• SHARP BLADE
cutting attachment
To prevent serious tnjury do not touch the
ne cutnng blade.
• ON/OFF STOP CONTROL
OK START / RUN
• ON/OFF STOP CONTROL
OFF or STOP
TB525CS & Muffler Spark Oil Fill Plug
TB575SS Plug
Shaft Grip
On/Off Stop
Control _ Starter
D-Handle Rope
Grip
Click Link
Shaft
•X4 Line
Cutting
Blade
Control
Fuel
Choke
Air Filter Primer
Cover Bulb
Cutting
INSTALLING AND ADJUSTING THE D-HANDLE
If your unit has the D-Handle pre-installed, please follow the
"To Adjust" instructions only.
To Install (4)Screws D-Handle
1. Removethe screws and f
bottom clamp piece that
were installed on the D-
handle for shipping.
2. Place the D-handle over Minimum
the shaft housing and 6 inches _ _
onto the bottom clamp (15.24 cm) -_.
(Fig. 1). Place it a Bottom
minimum of 15.24 cm (6 Clamp
in) from the end of the Fig. 1
shaft grip.
3. Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
To Adjust
4. If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
5. While holding the unit in the operating position, manuever
the D-handle to the location that provides you the best grip
(Fig. 12).
6. Tighten the clamp screws evenly, until the D-handle is
secure.
Cutting
Attachment
Loading ...
Loading ...
Loading ...