Loading ...
Loading ...
Loading ...
INSTALLATION AND OPERATION
5
Certifications
Installation
Install or locate this equipment only in accordance
with the instructions below.
Unpacking Instructions
1. Remove the unit carefully from the carton.
2. Before discarding packaging, check the packag-
ing thoroughly for accessories and literature.
3. Read all installation instructions carefully before
starting the installation.
Prepare the Plancha for Use
Before operating your Plancha:
• Keep the unit away from other heat sources and
allow at least 2” (51 mm) inches clearance for
air circulation at sides, front, and rear of the
unit. If either the air intake or exhaust outlet
is blocked, the internal temperature will rise,
causing an error code to occur.
• It is the responsibility of the installer to comply
with all federal, state, and local codes.
• Every installation site has different electrical
wiring. Because many different local codes exist,
it is the owner and installer’s responsibility to
comply with each applicable code. CookTek is not
responsible for any consequential damages that
may result from failure to comply with installation
requirements and local codes. See page ii for more
details.
• Any installation not matching the specifications
discussed in this manual automatically voids the
product’s warranty.
Operation
User Interface
The user interface on a CookTek Plancha unit
consists of two knobs for adjusting the setting,
a 4-digit display for visual verification of the
setting, and a button to change between power and
temperature control modes.
The 4-digit display on the top of the unit will
show the power setting or temperature setting.
If temperature mode is selected, the “F” or “C”
character will flash when the cooking surface is
below the set temperature. It will stop flashing when
the cooking surface has reached the set temperature.
The display will also show an error code in the event
of a failure.
Knob
When the knob is pointing up, the unit is off. Rotate
the knob clockwise. At 45 degrees, a detent will
indicate the lowest power or temperature setting.
Continue rotating the knob clockwise; each detent
indicates the next power or temperature setting.
Press the button to change from Power mode to
Temperature mode, or to change the Temperature
mode from Fahrenheit to Celsius.
The temperature setting range is 300-525˚F in
25-degree increments (150-260˚C in varying
increments).
Off
Rotate Clockwise
to Increase Power/
Temperature Settings
Power/Temperature
Toggle Button
Loading ...
Loading ...
Loading ...