Loading ...
Loading ...
Loading ...
ENGLISH 17
When the program is completed
and the door lock indicator “ ”
goes off, you can open the door.
While a program or the Delay Start is
operating, the appliance door is locked
and the display shows the indicator
“ ”.
First set the machine to PAUSE by
pressing the “Start/Pause” touchpad.
Wait until the door lock indicator “ ”
goes off, then the door can be opened.
If the door lock indicator “ ” does
not disappear, this means that the
machine is already heating and the
water level is above the bottom edge of
the door or the drum is turning. In this
case the door CAN NOT be opened.
If you can not open the door but you
need to open it you have to switch
the machine off by pressing the
“On/Off” button to deactivate the
appliance. After about 5 minutes the
door can be opened.
Pay attention to the water
level and water temperature.
CAUTION!
1.
3.
2.
When The Washing Program
Is Completed, But There Is
Water In The Drum
The drum turns regularly to
prevent the creases in the
laundry.
You must drain the water to open
the door.
The door lock indicator “ ” is
on. The door stays locked.
To drain the water:
Press the touchpad Start/Pause.
The appliance will drain the
water and spin.
If necessary, decrease the spin
speed.
Set the “Spin” program.
4.
Press the “On/Off” button to
deactivate the appliance.
5.
-
-
5.5 Opening The Door
5.7
The appliance stops automatically.
The acoustic signal will operate.
The display will show “ ”.
The indicator of the touchpad
Start/Pause goes off.
-
-
-
-
-
-
-
-
The door lock indicator “ ”
goes off.
Remove the laundry from the
appliance. Make sure that the
drum is empty.
Keep the door ajar, to prevent the
mildew and odours.
Turn off the water tap.
5.6 At The End Of The Program
At the end of the program the
time remaining can suddenly
decrease from 7 minutes or
less to 0 due to the
overestimated total program
time during the load sensing
phase. In some cases (with
perfectly balanced load) the
program time can be shorter
than the time estimated after
the load sensing phase is
completed.
This is a normal behavior of
the machine and not a cause
for concern as it does not
compromise its performance.
Loading ...
Loading ...
Loading ...