Loading ...
Loading ...
Loading ...
9
DOLBY PRO LOGIC* (NON-DIGITAL)
–
LINE LEVEL
Use this installation method
for Dolby Pro Logic applica-
tions (not Dolby Digital, DTS
or other digital processing),
where the receiver/proces-
sor is equipped with a sub-
woofer output, or a volume-
controlled preamp (line-)
level output:
Use RCA-type interconnects
to connect the line-level
subwoofer outputs on your
receiver or amplifier to the line-
level inputs on the subw o o f e r.
I M P O R TA N T: Do not use the
LFE input on the subwoofer
with Dolby Pro Logic proces-
sors.
N O T E : If your receiver or
amplifier only has one sub-
woofer output jack, then you
will need to use a Y- c o n n e c-
tor (not included). Plug the
male end of the Y- c o n n e c t o r
into your receiver or ampli-
f i e r ’s subwoofer output jack,
and connect each of the two
female ends to separate
RCA-type interconnects.
F i n a l l y, plug the RCA-type
interconnects into the line-
level inputs on the sub-
w o o f e r.
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
Make sure your receiver or
processor is correctly con-
figured to indicate that the
subwoofer is “On.”
Note for advanced users: If
your receiver/processor has
a built-in low-pass crossover
filter for the subwoofer out-
put, you may use the LFE
input to bypass the sub-
w o o f e r ’s internal crossover.
Use this installation method
for Dolby Digital, DTS or
other digital surround
processors:
Use the line-level input jack
marked “LFE” for the Low-
Frequency Effects channel.
Connect this jack to the LFE
output or subwoofer output
on your receiver or amplifier.
Connect each speaker to the
corresponding speaker
terminals on your receiver
or amplifier.
Make sure that you have
configured your surround
sound processor for “Sub-
woofer On.” Also configure
your receiver for 5.1-, 6.1- or
7.1-channel operation as
appropriate. (Satellite speak-
ers available separately) The
front left, front right, center
and rear speakers should all
be set to “Small.” If your
receiver allows you to set
the cross-over frequency
between the subwoofer and
the main speakers, select
120Hz or the setting that is the
closest frequency below it.
DOLBY* DIGITAL OR DTS
®
(OR OTHER DIGITAL SURROUND MODE) CONNECTION
DOLBY PRO LOGIC (NON-DIGITAL)
–
SPEAKER LEVEL
Use this installation method
for Dolby Pro Logic applica-
tions (not Dolby Digital, DTS
or other digital processing),
where the receiver/processor
does not have a subwoofer
output, or a volume-controlled
preamp (line-) level output:
Connect your receiver or
a m p l i f i e r ’s front left and right
speaker terminals to the left
and right terminals on the
subwoofer that are marked
“Speaker Level In.” Connect
the left and right terminals
on the subwoofer that are
marked “Speaker Level Out”
to the corresponding termi-
nals on the back of your front
left and right speakers.
Connect your receiver or
a m p l i f i e r ’s center, surround
and surround back speaker
terminals to the correspon-
ding terminals on the back of
your center and surround
s p e a k e r s .
8
Loading ...