Loading ...
GENERAL
The POLO ‘C’ range of convection panel heaters are designed for xed mounting on the wall bracket
supplied with each heater, or for portability on included castors. When used with the included castors, do not
use this heater in the immediate surroundings of a bath, shower or indoor swimming pool.
The POLO convection panel heaters should only be operated in the upright position as shown in Fig 1 with
the front outlet grill at the top and the controls on the right hand side.
All models are splash proof to IP24 and are suitable for use in bathrooms subject to the safety advice above.
The heater is tted with a cable and plug and is designed to be connected to a standard 10 amp socket outlet
located behind, or at the side or below the heater.
The heater is tted with a cable approx 1.4metres long and a three pin plug.
For economical operation do not use the heaters 24 hours a day. We recommend you set the thermostat wheel
to between 18-20 degrees Celsius and switch off the heaters when the room is not in use.
WALL MOUNTING
IMPORTANT – The wall bracket supplied with the heater must be used.
Minimum distances from objects
For objects of all types eg furniture, curtains, hangings or textiles or other ammable or non- ammable
materials, the following minimum distances from the unit must be observed – see Fig 1
To the front air outlet grill - 500mm
To the sides - 100mm
To the top - 150mm
To the underside - 100mm
Air must be able to enter the bottom of the heater unobstructed and be able to escape unobstructed through
the front grill.
The unit can only be used as freestanding by using the included castors
Do not stand on the unit when it is mounted on a wall.
DO NOT locate the heater immediately below a xed power point.
Fig 1 – Minimum distances from objects
Page 2
Loading ...
Loading ...
Loading ...