GE TBHA22RRELAD Diamond series Top-mount refrigerators

Use and Care Guide - Page 14

For TBHA22RRELAD. Series: Diamond

PDF File Manual, 20 pages, Read Online | Download pdf file

TBHA22RRELAD photo
Loading ...
Loading ...
Loading ...
PREPARATION
(contilmed)
Refrigerator Location
Do not install refrigerator where temperature will
go below 60:_F. because it will not run often enough
to maintain propel temperatures.
Do install it on a floor strong enough to support it
fully loaded.
Also _ee Energy-Saving Tips.
Clearances
Allow the following clearances for ease of
installation, proper air circulation and plumbing
and electrical connections:
Side._ ................................. 3/4"
Top....................................... 1"
Back.................................... _"
If refrigerator is to be installed against a wall on the
hinge side. allow 14.:"for door clearance.
Rollers/Leveling Legs
Some models have adjustable
rollers that allow you to move
the refrigerator away from the
wall for cleaning: other models
have adjustable leveling legs.
Rollers or legs should be set so the
relk'igei'ator is firnllypositioned on
file floor and the front i_ raised just
enough that the doors close easily
when opened about halfway.
Turn the two front roller adjusting
screx_ s or four comerlevel i ng legs
clockwise to raise the refrigemlor.
counterclockwise to lower il.
When adjusting rollers or
leveling legs for proper door
closure, we recommend that the
bottom front edge of the cabinet be
approximately 3/4" from the floor_
If your refrigerator has a
base grille, you can turn the
adjusting screws through
openings in the grille.
If you would rather remove the
base grille, grasp the bottom of the
grille and pull il out.
To replace the base grille, line up
the clips on the back of the grille
with the openings in the baseplate
and push the grille folward until it
snaps into place.
Water Supply to Icemaker
If your refrigerator has an icemaker, or if you plan to add an icemaker later,
theicemaker will have to be colmected to a cold water line. A water supply kit
containing copper tubing, shut-off valve, fittings aud instructions is available
at extra cost from your dealer. There should be sufficient tubing for the
ieemaker from the cold water supply to allow you to move the refrigerator om
from the wallseveral feet (approximately 9 feet of 1/4" copper tubing in three
1()" diameter col is).
14
Loading ...
Loading ...
Loading ...