Loading ...
Loading ...
Loading ...
ASSEMBLING YOUR BOWL-LIFT
STAND MIXER
Pre-Use Cleaning 4.
Before using your stand mixerfor
the first time, wash the mixing bowl
and accessories.Seethe "Care and
Cleaning" section.
Attaching Mixing Bowl
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
Placebowl brackets over the
locating pins on the bowl support.
5. Pressdown on the back of the
bowl until bowl pin snaps into
the spring latch.
6. Raisethe bowl before mixing.
7. Pluginto a grounded
3-prong outlet.
Raising and Lowering Mixing Bowl
1. To raise the bowl, turn the
bowl-lift lever counterclockwise
as far as possible.
Raise
1. Make sure the speed control lever
is set to the OFF/Oposition.
2. Unplug the stand mixer or
disconnect power.
3. Lower the bowl support by
turning the bowl-lift lever
clockwise.
Lower
2. The bowl-lift lever will snap
into place when the bowl is
completely raised.
3. To lower the bowl, turn the bowl-
lift lever clockwise.
Removing Mixing Bowl
1. Make sure the speed control
lever is set to the OFF/0
position.
2. Unplug the stand mixer or
disconnect power.
3. Lower the bowl support by
turning the bowl-lift lever
clockwise.
4. Grasp the bowl handle
and lift the bowl off of the
locating pins.
Continued on next page
Loading ...
Loading ...
Loading ...