Loading ...
Loading ...
Loading ...
page 7
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
hanging
bracket
canopy
screw
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Locate 12 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes
in blade with holes in blade arm (located
on the underside of the motor
housing)--refer to drawing at right. Then,
place blade plate under holes in blade,
making sure to align all 3 holes, as shown in
drawing at right. Insert 3 blade attachment
screws (along with washers) with fingers
first and then tighten screws securely with a
Phillips screwdriver. Repeat procedure for
each remaining blade.
Note: Tighten blade attachment screws
twice a year.
blade
blade plate
motor housing
blade attachment
screws and washers
blade arm
screw
canopy cover
Loading ...
Loading ...
Loading ...