Loading ...
Loading ...
Loading ...
Caring for Your microTALK
®
Radio
•
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure to
extreme temperatures.
Installing Batteries
•
To install or replace batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Using a flat head screw driver or edge of a coin
(a quarter may be used), remove the screw
securing the back battery panel.
3. Insert the supplied three AA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4. Replace battery compartment cover, screw and
belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the cable into the charge jack located at
the top of the radio.
3. Plug the cable into USB power source.
Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
Remove Belt Clip
Remove Screw
Insert Batteries
Introduction
1
Nothing Comes Close to a Cobra
®
Radio Charger Jack
CXT645_MANL_vB.indd 1 9/24/14 3:15 PM
Loading ...
Loading ...
Loading ...