Craftsman 536881850 8.5 Horsepower Electric Start Dual Stage Snow Thrower

Operator's Manual - Page 10

For 536881850. Also, The document are for others Craftsman models: 536.881850

PDF File Manual, 100 pages, Read Online | Download pdf file

536881850 photo
Loading ...
Loading ...
Loading ...
NOTE:Ifthecableshavebecomedis-
connected,connectcablesasshownin
Figure7.
TractionDriveCable AugerDriveCable
Figure7
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the carriage bolt. See
Figure 8.
2. Raise the chute deflector into op-
erating position.
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
4. Fasten with washer and Iocknut.
5. Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIG HTEN.
efiector
Nut /_'_/_ ''j Operp.ting_
Position
Washer J J_ \
,""-d" , . Carriage Bolt
Flange
Figure 8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjuet Skid Height paragraph in the
Service And Adjuetment section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see "How To Check
And Adjust The Cables" in the Service
And Adjustment section.
F-051015L 10
Loading ...
Loading ...
Loading ...