Loading ...
Loading ...
Loading ...
- STEP 5: INSTALL STORAGE TANK,
MAKE REMAINING TUBING CONNECTIONS -
1. CONNECT DRAIN TUBING, FAUCET TO
DRAIN ADAPTER: Referring to FIG. 8, run the loose
section (connected to faucet barb fitting) of black
3/ 8" tubing from the faucet to the drain adapter, with
a black collet, installed on page 6. Cut this tubing as
needed to route in as straight of a run as possible,
without loops, dips, low spots or kinks. Cut the end
of the tubing square. Then, push all the way into the
fitting. Pull on the tubing to be sure it's held firmly
in the adapter fitting. See pages 12 and 13 for tubing
connection instructions.
2. CONNECT TUBING TO WATER SUPPLY: Use the
tubinginsert, ferrule and nut to fasten the 1/4" green
tubing to the saddle valve fitting installed on page 5.
Tighten the nut with a wrench.
3. Move the storage tankinto place next to the RO as-
sembly. You can stand the tank upright, or lay it on
side. Apply Teflon tape to the threads on the nipple
at the top of the tank Turn the other included tubing
adapter fitting with the yellow collet onto the tank
nipple.
4. Run the 3/8" yellow tubing to the fitting installed
in step 3. Be sure the end of the tubing is cut square,
and insert all the way into the fitting. Again, pull on
the tubing to be sure it's held firmly in the fitting.
FIG. 8 ]
TYPICAL UNDERSINK INSTALLATION
RO product
water faucet
black tubing, to
larger barb on faucet
watersupply
saddlevalve
HOT COL[:
drain adapter
Note: See note on page 4
regarding tubing lengths.
YELLOW
CLOSE
insert
ferrule
nut
tubing adaptor
8
Loading ...
Loading ...
Loading ...