Loading ...
Loading ...
Loading ...
Air Purier
SHA 8400WH
EN
EN-9
2020 11/2020
• From the main unit A4 remove the frame with the lters A7. The frame has holders on both sides for easier removal.
D
• Use avacuum cleaner with an attached upholstery brush nozzle to remove the dirt from the pre-lter and
activated carbon lter. The pre-lter is attached to the frame with the combination lter with a velcro zip. Remove
the pre-lter from the frame and vacuum out the activated carbon lter located underneath it. When cleaning,
proceed with care so as not to damage any of the lters.
• In the event of signicant soiling of the pre-lter, wash it in lukewarm warm water. Then allow it to dry naturally.
Attention:
The activated carbon lter and HEPA lter are not washable.
• After cleaning, reinstall the pre-lter into the frame. Before reattaching the pre-lter into the frame, make sure
that it is completely dry. Reinstall the frame with the lters A7 into the main unit A4 and close the cover A9.
When inserting the lters, make sure that the HEPA lter points backwards towards the fan A3 and the pre-lter
forwards towards the front cover A9. The holders located on the sides of the frame point outwards from the
main unit A4 towards the front cover A9.
• Aashing LED indicator B1 will inform you when the lters A7 need to be replaced. The lifetime of the lters
A7 is approximately 6 months during standard use. You can purchase new lters from your vendor. Usually it is
necessary to only replace the frame with the activated carbon lter and HEPA lter and to reattach the exiting
pre-lter to it. Nevertheless, in the event that the pre-lter shows signs of wear, replace it also.
• After replacing the lters, it is necessary to restart the purier. Connect the power cord to apower socket. Turn on
the purier and then press button B5 and hold it down for approximately 5 seconds. This will restart the purier
and LED indicator B1 will stop ashing.
Loading ...
Loading ...
Loading ...