Loading ...
Loading ...
Loading ...
OCCURRENCE
POSSIBLE CAUSE SOLUTION
WASHER - OPERATING
(continued)
Washer does not start Cycle selector is not in correct position, Move indicator clockwise slightly Pull out knob
{continued).
Motor is overheated. Washer motor will stop if it becomes overheated. Itwill
automatically restart after a coot down period of up to
30 minutes (if washer has not been manually turned
off).
Washer won't spin. Lid is not completeEyclosed Closelidcompletely Safetylid iockmust not bebroken,
Residue left in tub. Heavilysoiled items Wipe tub with a nonabrasivehousehold cleanser,then
rinse Shake or brush excessdirt and sand from items
before washing.
WASHER - WATER
Wash load too wet after Washer is overloaded. Do not overload washer, SeeWashing Procedures.
spin.
Load is out of balance Rearrange load to allow proper spinning.
Drain hose iskinked. Straighten drain hose
Water does not enter Water supply is not adequate in area, _ Check another faucet in the house Wait until water
washer or it enters slowly, supply and pressureincrease.
Water supplyfaucetsarenot completely open. Fully open hot and cold faucets.
Water is being used elsewherein the house., Water pressure must be at least 30 psi (260 kPa) Avoid
running water elsewhere while washer is filling,
Water inlet hosesare kinked Straighten hoses.
Water level does not cover Improper ,water level selection (for Selecthigher water level/load size°
load. models with water level/load size control).
Washer is overloaded, Do not overload washer. When control is set at highest
fifl level, dry load level should not be higher than top
row of circular holes in wash tub
Warm or hot water is not Hot water heater isset too low or is a Measure hot water temperature at nearby faucet with
hot enough, distance from laundry center, candyormeat thermometer, Water temperature should
be at least 130°F (70°C) Adjust water heater as
necessary,
Hot water is being used elsewhere in
the house
Avoid using hot water elsewhere before or during
washer use, There may not be enough hot water
available for proper cleaning. If problem persists,your
hot water systemmay be unable to support more than
t use at a time.
Water in washer does not Drain hose is kinked or clogged Clean and straighten the drain hose
drain or drains slowly.
Water leaks. Fill hose connection at faucet or washer Check and tighten hose connections Install rubber
sealing washers provided.
Housedrain pipes are clogged, Unclog drain pipes,,Contact plumber if necessary
Oversudsing Uselessdetergent
Incorrect wash and rinse Hot and cold water hosesare connected Connect hot water hose to hot water faucet and cold
temperatures, to wrong supply faucets water hose to cold water faucet,
Water is entering washer Drain hose standpipe is incorrect height, Standpipe must be aminimum of 33" (83,82 cm) high
but tub does not fill, to prevent siphoning, See INSTALLATION
INSTRUCTIONS.
13
Loading ...
Loading ...
Loading ...