Loading ...
Loading ...
Loading ...
41
To remove the control panel:
1. Turn the control knobs to the OFF position and turn off the gas
supply to the unit.
2. Turn off the light switch and disconnect the power supply from the
power source.
3. Pull the control knobs from the stems and set aside .
4. Slowly lift away the lighted bezels to clear the valve stems, and
carefully disconnect the wires found on the back of the bezels (use
your fi ngernail). See Fig. 41-1.
5. Remove the smoker drawer and drip tray(s).
6. Using a Phillips screwdriver, unscrew and remove the control panel
fastener screws and washers (located on the left and right front face
of the control panel). Retain the screws for later re-installation .
7. Carefully open the control panel by lifting and pulling the control panel
from the frame , allowing it to rest on the internal chain(s).
Important: When opening, take caution to not damage any wiring.
8. If wire disconnections are required, reference the wire diagram in the
MODEL SPECIFICATIONS section in this instruction manual or the
wire diagram label affi xed to the inside of the control panel.
Note: Secure any disconnected wires (coming from the inside of the unit) to prevent them from falling in.
Note: Whenever reconnecting any wires, apply a small amount of dielectric grease to the male connector,
then make the connection.
Important: When reinstalling the control panel, set it back over the front lip of the grill so that the lid-
closed-sensor plunger protrudes through the hole on the upper right of the control panel
(if applicable). See Fig. 41-2.
Important: During reinstallation; prior to opening the gas shutoff valve , be sure the control knobs are
in the OFF position.
Fig. 41-1
Bezel
installed
Bezel
removed
Carefully
disconnect
Fig. 41-2
Lid-closed-sensor
(if equipped)
Protrude through hole
CONTROL PANEL REMOVAL
Loading ...
Loading ...
Loading ...