Loading ...
Loading ...
Loading ...
1716
Wok Cast Iron Burner (If applicable)
For proper lighting and performance of the burner, keep the electric
igniter and burner ports clean. It is necessary to clean these only when
the flame does not burn blue completely around all rings of the burner,
when there is a severe spillover or when the burner does not light, even
though the electric spark igniter sparks. Clean the burner by scraping off
burned on food soil. Use a wire, a straightened paper clip, or needle to
clean the ports. Do not use a toothpick; it could break off in the port. Be
sure the venturi tube remains dry.
Wok Pan w/Lid (If applicable)
Wash the wok after each use in hot, soapy water. Do not use harsh
abrasives or scouring pad as they can harm the protective seasoning.
Dry thoroughly. Apply a light coat of cooking oil to the inside surface
with a paper towel. Place over medium heat for 15 - 30 seconds.
Remove from heat and allow to cool. Wipe off excess oil before storing
in an inside cabinet. Do not store the wok pan and lid outdoors.
Orifice
Venturi tube
Burner
ports
Burner Caps
The surface burner caps should be routinely removed and cleaned.
Always clean the burner caps after a spill over. Keeping the burner caps
clean will prevent improper ignition and uneven flames. To clean, pull
burner cap straight up from the burner base. Wipe off surface burner
caps with warm, soapy water and a soft cloth after each use. Use a a non-
abrasive cleanser such as Bon Ami
TM
and a soft brush or soft Scotch
Brite
TM
pad for cooked-on foods. Dry thoroughly after cleaning. For best
cleaning and to avoid possible rusting, do not clean in dishwasher or
self-cleaning oven. When replacing burner caps, carefully align the tabs
underneath the cap with the outside edge of burner. Make sure burner
cap is level.
Sealed Burner Aluminum Base (If applicable)
The aluminum base should be wiped regularly with hot soapy water at
the end of each cooling period. Do not use steel wool, abrasive cloths,
cleanser, or powders. To remove encrusted materials, soak the area with
at hot towel to loosen the material, then use a wooden or nylon spatula.
Do not use a metal knife, spatula, or any other material tool to scrape the
aluminum base.
NOTE: For stubborn stains, use non-abrasive cleanser such as Bon Ami
TM
and a soft brush or soft Scoth Brite
TM
pad.
Loading ...
Loading ...
Loading ...