Loading ...
Loading ...
Loading ...
5
CARE AND MAINTENANCE
CAUTION
FAILURE TO UNPLUG THE ICE MAKER PRIOR TO CLEANING, MOVING, OR SERVICING COULD
RESULT IN ELECTRICAL SHOCK OR PERSONAL INJURY.
Ø CLEANING YOUR ICE MAKER
· TURN THE SWITCH CONTROL TO "OFF" POSITION, UNPLUG THE ICE MAKER AND REMOVE
THE BUCKET.
· WASH
THE INSIDE WITH A WARM WATER AND BAKING SODA SOLUTION. THE SOLUTION
SHOULD BE ABOUT 2 TABLESPOONS OF BAKING SODA TO A QUART OF WATER.
· WASH
THE BUCKET WITH A MILD DETERGENT SOLUTION.
· THE
OUTSIDE OF THE ICE MAKER SHOULD BE CLEANED WITH MILD DETERGENT AND
WARM WATER.
· THE
STAINLESS STEEL COMPONENTS OF THE DOOR SHOULD BE CLEANED WITH
STAINLESS STEEL CLEANER
· THE
CONDENSER COILS SHOULD BE VACUUMED WHEN THEY ARE DUSTY OR DIRTY.
NOTE:
PLACING THE ICE BUCKET IN THE DISHWASHER MAY CAUSE DISTORTION OF THE ICE
BUCKET.
Ø POWER FAILURE
MOST POWER FAILURES ARE CORRECTED WITHIN A FEW HOURS AND SHOULD NOT AFFECT
THE TEMPERATURE OF YOUR ICE MAKER IF YOU MINIMIZE THE NUMBER OF TIMES THE DOOR
IS OPENED. IF THE POWER IS GOING TO BE OFF FOR AN EXTENDED PERIOD OF TIME, YOU
SHOULD TAKE PRECAUTIONARY STEPS TO ENSURE WATER FROM THE DEFROSTING DOES
NOT LEAK OUT.
Ø VACATION TIME/STORAGE
1. SHUT OFF THE WATER SUPPLY AT THE MAIN WATER VALVE.
2. DISCONNECT
THE WATER SUPPLY LINE FROM THE VALVE.
3. ALLOW
THE UNIT TO RUN FOR AN HOUR OR TWO UNTIL ALL REMAINING ICE CUBES HAVE
BEEN EJECTED AND ALL WATER HAS CYCLED THROUGH THE SYSTEM AND HAS BEEN
MADE INTO ICE CUBES.
4. DISCONNECT
THE UNIT FROM THE MAIN POWER SOURCE.
5. DRY
OUT EXCESS WATER FROM THE ICE MAKER ASSEMBLY
6. LEAVE
THE DOOR OPEN AT LEAST TWO INCHES.
Ø MOVING YOUR ICE MAKER
· SECURELY TAPE DOWN ALL LOOSE ITEMS INSIDE YOUR ICE MAKER.
· TURN
THE LEVELING SCREWS UP TO THE BASE TO AVOID DAMAGE.
· TAPE
THE DOOR SHUT.
· MAKE SURE THE ICE MAKER STAYS IN THE UPRIGHT POSITION DURING
TRANSPORTATION.
Ø ENERGY SAVING TIPS
· THE ICE MAKER SHOULD BE LOCATED IN THE COOLEST AREA OF THE ROOM, AWAY FROM
HEAT SOURCES, AND OUT OF THE DIRECT SUNLIGHT.
Loading ...
Loading ...