Loading ...
2
IMPORTANT SAFETY INSTRUCTIONS
~WARNING~
FOLLOW
THESE BASIC PRECAUTIONS
TO
REDUCE
THE RISK OF FIRE,
ELECTRICAL
SHOCK,
OR INJURY WHEN USING YOUR
ICE
MAKER.
·
READ ALL INSTRUCTIONS BEFORE USING THE ICE MAKER.
·
DANGER: RISK OF CHILD ENTRAPMENT.
CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST.
JUNKED
OR ABANDONED APPLIANCES ARE STILL DANGEROUS.
·
BEFORE YOU THROW AWAY YOUR ICE MAKER: TAKE OFF THE DOOR.
·
NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE
APPLIANCE.
·
NEVER CLEAN ICE MAKER PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.
·
DO NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND
LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES CAN CREATE A
FIRE
HAZARD OR EXPLOSION.
INSTALLATION INSTRUCTIONS
Ø BEFORE USING YOUR ICE MAKER
· REMOVE THE EXTERIOR AND INTERIOR PACKING.
· VERIFY
THAT YOU HAVE ALL OF THE FOLLOWING PARTS:
· 1
ICE BUCKET
· 1
PLASTIC SCOOP
· 1
HOSE, 25 FT.
· 1
INSTRUCTION MANUAL
· BEFORE
INSTALLING AND USING YOUR NEW ICE MAKER, LET IT STAND UPRIGHT FOR A
MINIMUM OF 4 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A COOLING SYSTEM
MALFUNCTION FROM IMPROPER HANDLING DURING TRANSPORTATION.
· CLEAN
THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.
Ø INSTALLATION OF YOUR ICE MAKER
· THIS APPLIANCE IS DESIGNED TO EXHAUST HOT AIR THROUGH THE FRONT VENT. THIS
ALLOWS FOR INSTALLATION IN A RECESSED OR BUILT-IN APPLICATION, IF DESIRED.
· PLACE
YOUR ICE MAKER ON A LEVEL SURFACE THAT IS STRONG ENOUGH TO SUPPORT
THE ICE MAKER WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL BE
SIGNIFICANTLY HEAVIER ONCE IT IS OPERATIONAL AND FULLY LOADED. LEVEL YOUR ICE
MAKER BY ADJUSTING THE LEGS AT THE FRONT OF THE ICE MAKER.
· LOCATE
THE ICE MAKER AWAY FROM DIRECT SUNLIGHT AND OTHER HEAT SOURCES
(STOVE, HEATER, RADIATOR, ETC.). DIRECT SUNLIGHT MAY AFFECT THE FINISH.HEAT
SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREMELY COLD AMBIENT
TEMPERATURES MAY CAUSE THE ICE MAKER TO MALFUNCTION. THIS ICE MAKER IS
DESIGNED FOR INSTALLATION AND USE INDOORS IN CONTROLLED AMBIENT
CONDITIONS.
· AVOID
LOCATING THE ICE MAKER IN MOIST/HUMID AREAS. EXCESS MOISTURE IN THE AIR
MAY CAUSE FROST TO FORM QUICKLY ON THE EVAPORATOR AND CABINET, REQUIRING
FREQUENT DEFROSTING. THE ICE MAY ALSO STICK TOGETHER
· PLUG
THE ICE MAKER INTO A DEDICATED, PROPERLY INSTALLED GROUNDED WALL
OUTLET. DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER PLUG. ANY QUESTIONS CONCERNING POWER AND/OR
GROUNDING SHOULD BE DIRECTED TOWARD A CERTIFIED ELECTRICIAN.
Loading ...
Loading ...
Loading ...