Loading ...
Loading ...
Loading ...
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the circuit breaker located on the treadmill frame near the power cord. If the switch
protrudes, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and
then pl'ess the switch back in. (See the drawing above.)
b. Make sure the power cord is plugged in.
c. Remove the safety key from the console. Wait for ten seconds and then reinsert the safety key
fully into the console. Various indicators on the console should light.
3. SYMPTOM: THE ELECTRONIC MONITOR DOES NOT FUNCTION PROPERLY
a. Using a small screwdriver, remove the two screws attaching the electronic monitor and gently
pry the monitor out of the console. Make sure the power and speed wires are plugged fully into
the monitor. (See the Electronic Monitor Operation Guide:)
4. SYMPTOM: THE CONSOLE LOCKS UP
a. Unplug the power cord, wait for 10 seconds, and plug the power cord back in. Each time the
safety key is removed from the console, wa t for 10 seconds before reinserting the key.
5. SYMPTOM: THE PULSE EARCLIP DOES NOT FUNCTION PROPERLY
a. Make sure the pulse earclip is plugged fully into the electronic monitor. Attach the clothes clipto
your collar. Rub your left ear lobe and reposition the earclip.
b. Try standing still while measuring your pulse. The pulse earclip is not a medically certified
device. External factors such as movement may affect heart rate readings.
c. The pulse earclip may need to be cleaned. Press the earclip open, and wipe the two clear
circles inside the earclip, using a cotton swab saturated with denatured alcohol,
6. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a.
Silicone lubricant should be applied to the walking platform before use. Lubricant should b_
reapplied after every 10 hours of use, and whenever a decrease in performance is noticed. UNI
SPORT Silicone Spray is recommended. CAUTION: ALWAYS TURN THE POWER OFF
WHEN APPLYING LUBRICANT. (See OPERATION AND ADJUSTMENT in this manual for
application instructions.)
b. If an extension cord is necessary, use only a 14-gauge general-purpose cord of approximately
five feet in length.
Co
If the walking belt is overtightened, treadmill perfor-
mance may be reduced. TURN THE POWER OFF.
Turn both rear roller adjustment bolts counterclockwise,
1/4 of a turn. Repeat as necessary until the tension of
the walking belt is correct: When the tension is correct,
you should be able to lift each side df the walking belt
2-3 in. off of the walking platform. The center of the
walking belt should remain just at the surface of the
walking platform. Be careful to keep the walking belt
centered on the walking platform.
11
Loading ...
Loading ...
Loading ...