Loading ...
Loading ...
Loading ...
Afteralltensegmentshavebeencompleted,thewalkingbeltwitlslowto a stop and the program will
end. Note: If you wish to stop the walking belt before the program has ended, press the STOP key.
The console will then be in the same state as if the program had ended,
IMPORTANT: If you want to change any program settings after the program has been started, press
the STOP key, and then make the desired changes. The program can be restarted by pressing the
PROGRAM START key. Changing settings while the program is running could cause the speed of the
walking belt to increase suddenly.
After the program has ended, the program can be restarted, a different program can be selected by
pressing one of the other USER keys or the console can be switched to the manual mode by pressing
the MANUAL key. When the console is switched to the manual mode, or the power is turned off, the
current settings of the ten segments will be stored in memory. Programs will be stored as long as the
power cord remains plugged in. When the power cord is unplugged, programs will be erased,
TURNING THE POWER OFF
To turn the power off, remove the safety key from the console. Store the safety key in a secure loca-
tion to prevent small children from operating the treadmill. NOTE: After removing the safety key from
the console, wait for ten seconds for the microprocessor to power down before re:inserting the key.
TROUBLE-SHOOTING AND MAINTENANCE
10
Most treadmill problems can be solved by following the simple steps below. Find the symptom
that applies, and follow the steps listed. If further assistance is necessary, please call our Customer
Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m, until 6 p.m. Mountain
-tqme (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure the power cord is plugged into a properly grounded outlet. (See OPERATION AND
ADJUSTMENT in this manual.) If an extension cord is necessary, use only a 14-gauge, general
•purpose cord of approximately five feet in length.
b. Make sure the safety key is fully inserted into the console. Various indicators on the console
should light. (See OPERATION AND ADJUSTMENT in this manual.)
C. Check the circuit breaker located on the treadmill frame
near the power cord. If the switch protrudes as shown,
the circuit breaker has tripped. To reset the circuit
breaker, wait for five minutes and then press the switch
back in.
3"ripped
Reset
Loading ...
Loading ...
Loading ...