Loading ...
Loading ...
Loading ...
Problem solving guide
105
Problem Cause and remedy
At the end of the pro-
gramme, the buzzer
sounds and the display
shows the following
message:
Fault F601
There is a fault in the AutoDos.
Switch the dishwasher off and back on again.
Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see the “De-
tergent” chapter, “Automatic dispensing/AutoDos”
section).
Activate the AutoDosfunction and start the pro-
gramme again.
If the fault message appears again, there is a tech-
nical fault. You can continue to use your dishwasher
by deactivating automatic dispensing using the
AutoDossensor control and manually dispensing
the detergent into the detergent compartment.
If you wish to use automatic dispensing again,
contact Miele Service.
At the end of the pro-
gramme, the alarm tone
sounds and the display
shows the following
message:
AutoDos maintenance re-
quired
The dishwasher does
not switch off at the end
of the programme.
The wash items may not
be clean because an in-
sufficient amount of de-
tergent was dispensed.
The AutoDosfunc-
tion is automatically de-
activated during the
programme sequence.
An empty PowerDisk has been inserted or the Auto-
Dos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDosfunction was automatically deactiv-
ated.
Switch the dishwasher off and back on again.
Multiple messages appear in the display.
Clean the pouring channel of the AutoDos (see
“Detergent” chapter, “Cleaning the AutoDos” sec-
tion).
Clean the lower spray arm (see “Cleaning and
care” chapter, “Cleaning the spray arms” section).
Select OK to confirm each message.
Activate the AutoDosfunction by confirming the
messageAutoDos available using OK.
Start the programme again.
The programme duration will be extended by up to
2.5hours to flush out the AutoDos detergent outlet.
Loading ...
Loading ...
Loading ...