Loading ...
Loading ...
Loading ...
CLEANING AND MAINTENANCE - 3191477A540/A
e
towards the knobs.
Insert the central pan support (2) by slotting the
recesses onto the lugs of the lateral pan
supports.
The word "FRONT” is marked under the front of
each pan support. The supports should be
positioned so that it is facing towards the front of
the appliance.
Precautions when using the griddle
A few precautions are necessary if you wish to
use a griddle:
• The griddle must not extend beyond the
edge of the hob.
• Do not place the griddle over more than
one burner at the same time.
• The griddle can be pre-heated on the
burner at maximum power for no more than
10 minutes.
• Make sure that the burner flame does not
extend beyond the edge of the griddle.
• Keep a distance of at least 160 mm
between the griddle and the side and/or
rear wall, especially if it is placed on an
Ultra-Rapid burner.
• It is not recommended to use earthenware
or steatite griddles.
• Never use the griddle for more than 40
minutes.
CLEANING AND MAINTENANCE
Cleaning the hob
Cooking hob pan support grids
Remove the pan support grids and clean them in
lukewarm water and non-abrasive detergent.
Make sure to remove any encrustations. Dry
them thoroughly and return them to the hob.
Flame-spreader crown and burner caps
For easier cleaning, the flame-spreader crowns
and the burner caps can be removed. Wash
them in hot water and non-abrasive detergent.
Carefully remove any encrustation, then wait
until they are perfectly dry. Replace the flame-
spreader crowns, making sure that they are
correctly positioned in their housings with their
respective burner caps.
Igniters and thermocouples
For correct operation the igniters and
thermocouples must always be perfectly clean.
Check them frequently and clean them with a
damp cloth if necessary. Remove any dry
residues with a wooden toothpick or a needle.
The continuous contact between the
pan supports and the flame can cause
modifications to the enamel over time in
those parts exposed to heat. This is a
completely natural phenomenon which
has no effect on the operation of this
component.
Loading ...
Loading ...
Loading ...