Loading ...
Loading ...
Loading ...
30 - USE 91477A540/A
USE
Precautions
A gas leak can cause an explosion.
If you smell gas or there are faults in the gas
system:
• Immediately turn off the gas supply or close
the valve on the gas cylinder.
• Extinguish all naked flames and cigarettes.
• Do not turn on power switches or
appliances and do not remove plugs from
power sockets. Do not use phones or
mobile phones inside the building.
• Open the window in order to ventilate the
room.
• Call customer assistance services or your
gas supplier.
Malfunctions
Any of the following indicate a malfunction and
you should contact a service centre.
• The burners do not ignite properly.
• It is difficult to keep the burners lit.
• The burners go out when the appliance is in
use.
• It is difficult to turn the gas cocks.
Practical tips for using the hob
For better burner efficiency and to minimise gas
consumption, use pans with lids and of suitable
size for the burner, so that the flames do not
reach up the sides of the pan. Once the contents
come to the boil, turn down the flame far
enough to ensure that the liquid does not boil
over.
Using the hob
All the appliance’s control and monitoring
devices are located together on the front panel.
The burner controlled by each knob is shown
next to the knob. The appliance is equipped
with an electronic ignition device. Simply press
the knob and turn it anti-clockwise to the
maximum flame symbol, until the burner ignites. If
the burner does not light in the first 15 seconds,
turn the knob to and wait 60 seconds
before trying again. After lighting, keep the knob
pressed in for a few seconds to allow the
thermocouple to heat up. The burner may go out
when the knob is released: In this case, the
thermocouple has not heated up sufficiently.
Wait a few moments and repeat the operation.
Keep the knob pressed in longer.
Correct positioning of the flame-spreader
crowns and burner caps
Before lighting the hob burners, make sure that
the flame-spreader crowns are correctly
positioned in their housings with their respective
burner caps. Make sure that the holes 1 in the
flame-spreader crowns are aligned with the
igniters 3 and thermocouples 2. Also ensure that
the flame-spreader crowns are correctly
engaged in the burner holes.
Correct positioning of the pan supports
Place the lateral pan supports on the hob (1),
making sure that the front lugs are facing
See General safety instructions.
Burner Pan diameter
AUX 12 - 18 cm
SR 14 - 24 cm
R 20 - 26 cm
UR - UR2 - UR3 20 - 30 cm
In case of an accidental switching off, a
safety device will be tripped, cutting off
the gas supply, even if the gas cock is
open. Return the knob to and wait
at least 60 seconds before lighting it
again.
Loading ...
Loading ...
Loading ...