Loading ...
Loading ...
Loading ...
©2017 Hestan Commercial Corporation
14
EN
Your Aspire grill for use with Natural Gas is supplied with its own regulator which MUST NOT be
removed. If this regulator needs to be replaced, use only the type specified by Hestan for this appliance.
TO CONNECT THE REGULATOR / HOSE ASSEMBLY FOLLOW THE NEXT STEPS:
1. Locate the regulator and gas connection point in the rear right side of your grill (in cart-mounted models,
remove the rear panel to gain access).
2. Install the natural gas regulator as shown. Connect gas supply using a minimum 1/2” diameter flexible
(semi–rigid) stainless steel gas hose, no more than 48” in length. The hose as well as the connectors
must comply with the
Standard for Connectors for Outdoor Gas Appliances and Manufactured Homes,
ANSI Z21.75 • CAS 6.27
, and suitable for outdoor installation. Use the appropriate thread sealant on all
connections.
3. Proceed to LEAK TESTING section.
GAS CONNECTIONS
(continued)
GAS CONNECTION - LIQUID PROPANE (LP) CYLINDER
Your Aspire grill for use with LP gas is
supplied with a two-stage regulator/hose
assembly for connection to a standard
20 lb. LP gas cylinder. This assembly
must be used WITHOUT alteration.
If this assembly needs to be replaced,
contact your Hestan dealer for genuine
replacement P/N 014309.
NOTE: To ensure proper heating
performance of this appliance, verify that
the supply pressure is adequate. Use only
the gas pressure regulator supplied with
this appliance. This regulator is set for
an outlet pressure of 11 inch WC (2.74
kPa) to maintain 10 inch WC (2.49 kPa)
manifold pressure.
2-STG. LP
REGULATOR / HOSE
ASSEMBLY
ADAPTER, 3/8 FLARE
X 1/2 NPT FEMALE
20lb LP
TANK
TYPICAL ASPIRE GRILL
(36” MODEL SHOWN)
TO CONNECT THE REGULATOR / HOSE ASSEMBLY FOLLOW THESE STEPS:
1. Locate the regulator and gas connection point in the rear right side of your grill (in cart-mounted models,
remove the rear panel to gain access).
2. Connect the regulator/hose assembly to the 3/8” Flare (compression flare fitting) X 1/2” NPT female
adapter as shown.
3. Connect the regulator/hose assembly to a standard 20 lb. LP cylinder. The hose as well as the connectors
must comply with the
Standard for Connectors for Outdoor Gas Appliances and Manufactured Homes,
ANSI Z21.75 • CAS 6.27
, and suitable for outdoor installation. Use the appropriate thread sealant on all
connections.
4. Proceed to LEAK TESTING section.
GAS CONNECTION - LP PIPED SYSTEMS
Loading ...
Loading ...
Loading ...