Loading ...
Loading ...
Loading ...
Doe het volgende voordat u uw kooktop gaat gebruiken:
• Verwijder al het verpakkingsmateriaal
• Zet het toestel op een droge, vlakke, harde, stabiele en onbrandbare ondergrond
• Houd het toestel uit de buurt van andere warmtebronnen en zorg dat er aan de
voor- en achterkant en de zijkanten minstens 5 cm vrij is voor luchtcirculatie.
Voor uw veiligheid mag u nooit de elektrische (massa) aansluiting uit de stekker
snijden, verwijderen of uitschakelen. Gebruik nooit een aangepaste stekker of een
verlengsnoer met de kooktop.
No power (no
lights or fan
noise.)
• Unit unplugged.
• No power to
receptacle.
• Plug unit into appropriate
receptacle.
• Make sure that receptacle is
energized.
• Check wall switches.
• Check circuit breaker.
• Plug a different electronic device
into the receptacle to make sure
that power is present.
Pot does not
heat.
• Pot is not induction
efcient.
• Pot not centered.
• Use induction efcient pot.
• Center pot.
Stock pot heater
suddenly stops
heating.
• Possible power brown
out.
• Circuit shared with
another electrical
device.
• Safety shut-off
engaged.
• Assure proper voltage/power levels.
• Make sure the stock pot heater is
not sharing a circuit with electrical
devices.
• The safety shut-off will engage if
an empty pot is left on the stock
pot heater’s surface while the unit
is working at full power. Make sure
that the stock pot heater’s surface
is clear. Wait 15-20 minutes for the
unit to reset.
Pot does not
get hot enough
even though
power levels are
set to maximum
– induction
efcient pot in
use.
• Extension cord in use.
• Circuit shared with
another electrical
device.
• DO NOT use extension cords.
Extension cords may affect
the power levels reaching the
appliance.
• Make sure that the stock pot heater
is not sharing a circuit with other
electrical devices.
Pot heats
unevenly, does
not maintain
heat level, or
overheats.
• Pot is not induction
efcient.
• Pot bottom may not be
at enough.
• Pot not centered.
• Use induction efcient pot.
• Use atter pot.
• Center pot.
In the event of a possible malfunction, your CookTek stock pot heater will ash an
error code on the LED display. Please consult the following table when encountering
an error code. To reset error conditions, remove the pot from the unit and turn the
knob until it is off, or unplug the unit.
1 Temperature sensor
failure.
Turn the unit off. Allow to cool.
If error persists, unit requires
service.
2 Incompatible pot. Use a different, induction-efcient
pot.
3 Internal componet
failure.
Unit requires service.
4 Unit overheated.
Insufcient air ow.
Clean grease lters. Make
sure proper clearance space is
maintained around unit. If error
persists, unit requires service.
5 Incompatible pot. Use a different, induction-efcient
pot.
6 Supply voltage too high. Check power supply. Turn off/on.
If problem persists, unit requires
service.
7 System hardware failure. Unit requires service.
8 Same as E2 & E5 except
for display.
9 Same as E7 except for
display.
10 Same as E7 except for
display.