Loading ...
Loading ...
Loading ...
NOTE:WHENOPERATINGTRACTORWITHOUTMOWER;
REMOVEIDLERBRACKETFROMFRONTOFTRACTOR,
1,PullBeltupthroughIdlerBracketandoutoftractor_Use
LevertoswingTensionPulleyforBeltremoval.
2oRemoveLoekwashersand Nuts from idler Bracket (Fig.
32).,
IDLER
BRACKET
NUT
STORAGE
Remove mower from tractor" for" winter storage. When mower
is to be stored for a period of time, clean it thoroughly, re-
move all dirt, grease, leaves, etc. Give blades and underside of
housing a good coat of grease or rust preventative. Store in a
clean dry area.
FIGURE 32
LEVER
NUT
LOCI<WASHER
SPRING
BUSHING
TTACH_NT
'SPRING
FIGURE 33
JAM NUT
DISCHARGING
D C AMPERES
0 5 0 5
CHARGING
AMMETER
ATTACHMENT LIFT ADJUSTMENT
Due to different weights of Attachments, the Attachment
Lift Spring may require adjustment. The Adjustment Bolt
is located on rear of tractor top left side (Fig. 33)
1. Holding Spring Bushing with Wrench, loosen Jam Nut.
2 Turn Adjustment Bolt clockwise (f'_) to extend Spring
and reduce lift effort (for heavier Attachments).,
3. Turn Adjustment Bolt counterclockwise (("_ } {for lighter
Attachments).
4. Retighten Jam Nut against Spring Bushing.
NOTE: DO NOT ADJUST FOR MAXIMUM SPRING TEN-
SION WHEN USING LIGHT ATTACHMENTS SUCH AS A
MOWER. ADJUST LIFT SPRING TO AID IN LIFTING
ATTACHMENT - DON_T OVER POWER SPRING. WHEN
REMOVING ATTACHMENT ALWAYS ADJUST WITH
SPRING TENSION TO ITS LOWEST POSITION.
TRACTOR MAINTENANCE
INSTRUCTIONS
To keep your tractor running better, longer; perform nec-
essary service using the following Maintenance Schedule=
Each time you start your tractor, check your Ammeter (Fig..
34). The needle should move towards the + (charging) mark
indicating the battery is being charged as you operate the trac-
tor. The headlights will not show a discharge on the ammeter
because they are not connected to the battery (they have their'
own electrical source, see page 26). If you have a lift motor
connected it will show a discharge when being operated.
DISCONNECT SPARK PLUG WIRES TO
PREVENT ACCIDENTAL STARTING BE-
FORE MAKING ANY INSPECTION, AD-
JUSTMENT OR REPAIR (EXCEPT CAR-
BURETOR)o
FIGURE 34
_16-
Loading ...
Loading ...
Loading ...