Bosch WAK24161AU Washing Machine

User Manual - Page 14

For WAK24161AU.

PDF File Manual, 36 pages, Read Online | Download pdf file

WAK24161AU photo
Loading ...
Loading ...
Loading ...
en Positioning and connecting
14
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
correctly installed and connected
~ Page 8
Never use a damaged machine.
Inform your after-sales service.
~ Page 34
1. Check the machine.
2. Remove the protective film from the
control panel.
3. Connect the mains plug.
4. Turn on the water tap.
5. Close the washing machine door (do
not load any laundry).
6. Select the l Drum clean
programme.
7. Open the detergent drawer.
8. Pour approx. 1 litre of water into
compartment II.
9. Pour standard detergent into
compartment II.
Note: To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.Close the detergent drawer.
11.Press Start/Reload A .
12.Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply ~ Page 29
3. Disconnect the washing machine
from the main plug.
4. Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked ~ Page 28
5. Remove the hoses.
Before initial use:
Notes
The transport locks must be
removed. ~ Page 10
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour
approximately 1 litre of water into
compartment II and select and start
the 0 Spin/Drain [ programme (if
only drain cycle is required, set
rpm 0 on - - - ).
Installing the transport locks:
1. Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2. Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Loading ...
Loading ...
Loading ...