Wagner Spraytech HVLP

User Manual - Page 9

For HVLP.

PDF File Manual, 13 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
English
© Wagner Spray Tech - All Rights Reserved 9
Cleanup (continued)
Cleaning the Gun
To Clean the Nozzle:
1. Make sure power cord is unplugged. Push the tab below
the trigger, twist and separate the spray gun from the
turbine.
2. Wipe the exterior of the cup and gun until clean.
3. Unscrew the nut and remove the air cap and nozzle.
4. Remove the parts as shown*. Clean all parts with a
cleaning brush and the appropriate cleaning solution.
Reassemble all parts when clean** (see “Nozzle Seal”).
5. Clean the rear of the gun (d) with the appropriate
cleaning solution. Use a thin layer of petroleum jelly to
lubricate the O-ring (e).
Reassemble the spray gun.
(c)
(d)
4 53
2
1
* Nozzle seal
The red nozzle seal may become
stuck inside the nozzle when the
nozzle is removed. If this occurs,
make sure to pull it out.
** It is important that the nozzle seal inside the
nozzle be re-installed properly. Make sure the cup
side of the seal (the side with the groove) is facing out
towards the front of the nozzle. Improper installation
will cause leakage and damage to the turbine.
Groove
Loading ...
Loading ...
Loading ...