Loading ...
Loading ...
Loading ...
English
© Wagner Spray Tech. - All Rights Reserved 5
Material Preparation
Note: Material to be sprayed may need to be strained
to remove any impurities in the paint which may enter
and clog the system. Impurities in the paint will give
poor performance and a poor finish.
Thinning the material:
Before spraying, the material being used may need
to be thinned with the proper solvent as specied by
the material manufacturer. Never exceed the thinning
advice given by the coating manufacturer.
Note: Only thin the material if absolutely necessary
to improve spray performance. Optimal spray
performance should be acheived simply by adjusting
the various controls on the unit.
Do not thin with materials that have
a ashpoint below 100°F (38°C). The
material ashpoint should be shown on
the material container.
To Prepare the Material:
1. Stir the spraying material thoroughly. Unscrew the
cup from the spray gun.
2. Secure the thinning accessory to the side of the
container as shown. The accessory should sit
perfectly vertical.
3. Fill the container with spray material to the bottom
of any of the notches on the accessory.
4. Add the appropriate thinning agent (Wagner Paint
Easy or mineral spirits for solvent-based materials).
For every notch that the uid level in the container
rises, the spray material is diluted by 10%.
Note: It is recommended that the material be thinned
in increments of 10%, but not more than the material
manufacturer’s recommendations.
5. After the material has been properly thinned and
strained, ll the container to the top of the neck.
1
5
= 10%
= 10%
Material
Paint Easy /
Mineral Spirits
42 3
Loading ...
Loading ...
Loading ...