Loading ...
CASTER INSTALLATION:
NOTE: Use adequate manpower for this
operation.
• Lay the unit on its back, use packaging
material to protect the paint finish
• Attach the casters to unit using (4) 1/4-
20 x 7/16" screws and (4) 1/4-20 nuts
Mount both swivel casters on the same
side of the unit Wrench tighten
\\\
DRAWER REMOVAL:
• Fully extend the drawer. Push it back a
quarter of an inch.
• Insert a screwdriver into the slot in the
slide and push in on the stop until it
clears the lance. Repeat the procedure
on the other slide and remove the
drawer.
Slot
y-Stop
..... Lubricate
To reinstall the drawer, pry the stop far
enough out to engage the lance (3/16" to
1/4") and push the drawer onto the
slides until the stops pass over the
lances.
• Return the unit to its upright position.
PLASTIC TOP INSTALLATION:
• Remove the top two drawers to gain
access to the holes pre-drilled in the
metal top.
• Attach using (4) #14-10 x 5/8 screws.
• For casters, use high quality bearing
grease, (yearly).
• Lubricate the slides, (twice yearly).
• Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and water.
• Auto wax wilt preserve the storage unit's
luster finish. Apply the wax as to a car.
The wax wilt also help protect the unit
against scratches.
• Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable cleaning
fluid.
3 4
Loading ...
Loading ...