Loading ...
Loading ...
Loading ...
Document Number: 950-0042 Description: MANUAL, JBL 4.1, All languages
Revision: 06
Check the speaker control
settings.
Set each of the two knobs
(treble, bass level) on front
of the subwoofer back the
their center /nominal
positions.
Too much bass or treble. Bass/Treble level is set too
high
Turn Bass/Treble down or
return their settings to the
center position.
Subwoofer emits a loud
hum or buzzing noise.
Input cables not plugged in
properly
Check input cable
connection
Wrap up excess input
cable in order to make as
short as possible
Speaker system
experiences radio
frequency interference or
picks up a radio station
Input cable may be picking
up interference
Purchase a ferrite clamp
and attach over input
cable. A clamp can be
purchased at your local
electronics store
SPECIFICATIONS
Regulatory
FCC Statement and Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
a) Re-orient or relocate the receiving antenna.
b) Increase the separation between the equipment and receiver.
c) Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT
UNDER FCC RULES.
Manufacturer Harman Multimedia
Model JBL INVADER
Drivers (satellite) Phoenix SE
Drivers (subwoofer) One 6 inch Magnum woofer
Power (satellite) 12 watts per satellite at 1% THD
Power (subwoofer) 32 watts at 1% THD
Crossover Frequency (subwoofer) 150 Hz
Dimensions
Width:
Satellite 3.0 inches 75mm
Subwoofer 7.5 inches 190mm
Depth:
Satellite 4.0 inches 100mm
Subwoofer 9.0 inches 225mm
Height:
Satellite 9.5 inches 240mm
Subwoofer 12 inches 300mm
Input Impedance >5k Ohm
Signal-to-Noise ratio >85dB
Frequency Response 40 – 20 kHz
Input Sensitivity 400 mV rms for rated power output
USA/Canada Power 120 volts, 60Hz AC
Maximum Power Consumption 120 watts
UL/CUL/CE Approved
Loading ...
Loading ...
Loading ...