Loading ...
Loading ...
Loading ...
3. Lay the dryer door on a flat, protected surface with the inside
Level Dl"yel" door assembly facing up. Remove the last screw from Step 1.
Remove the 2 screws holding the handle to the door.
Check the levelness of the dryer. Check levelness first
side to side, then front to back.
Ifthe dryer is not level, prop upthe dryer using awood block.
Use a wrench to adjust the legs up or down and check again for
levelness.
NOTE: It might be necessary to levelthe dryer again after it has
been moved into its final position.
Connect Vent
1. Using a 4" (10.2 cm) clarop, connect vant to exhaust outlst in
dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.
2. Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.
3. (On gas models) Check to be sure there are no kinks in the
flexible gas line.
Reverse Door Swing
You can change your door swing from a right-side opening to a
left-side opening, if desired.
Remove the door
1. Open the dryer door. Remove the 4 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening last (second
from the top).
4,
5,
_®"
J
Remove the 6 screws to release the outer door assembly
from the inner door assembly (see illustration). It is important
that you remove onlythe 6 indicated screws.
Liftthe inner door assembly off ofthe outer door sseambly.
Unsnap the handle from the outer door assembly, move it to
the other side, and snap in. Set the outer door assembly
aside.
2,
A. Dryer
B. Do not remove
C. Dryer door
Lift and pull forward on the door so that the keyhole clears
the screw head. Remove the door.
Reverse the hinge and hinge bracket
1. Place the inner door, screw head side up, on the work
sur_ac8.
2. Remove the 4 screws that hold the hinge to the door.
16
Loading ...
Loading ...
Loading ...