Loading ...
Loading ...
Loading ...
www.bissell.com
Assembly
6
Your Lift-Off deep cleaner comes in
two easy to assemble components:
1. Upper handle
2. Portable spot cleaner/Base
The only tool you will need to
assemble your cleaner is a long
Phillips screwdriver.
1. Slide the upper handle onto the body
of the machine by guiding the 2 posts
on the body into the opening on the
upper handle.
2. Firmly holding the upper handle in
place, screw 2 screws into the marked
holes at an upward angle above the
support handle.
3. At an upward angle, screw the remaining
2 screws into the marked outermost holes
under the support handle.
4. Wrap power cord around Quick
Release Cord Wrap.
5. Wrap flex hose around the hose wrap
and secure with hose secure latch.
6. Align the product as image 4 shows
and firmly push down the portable spot
cleaner until it is secured on both sides.
7. Check latches on both sides to confirm
it is secured (5).
8. Snap attachment(s) into the back of unit.
NOTE: Portable spot cleaner must
be fully secure to operate in the
upright mode.
To further check if the portable
spot cleaner is secure, plug in
and turn on to verify that the
heat indicator light is illuminated.
If the heat indicator light does
not illuminate, release the pod
and re-secure by pushing firmly
until both sides snap into place.
WARNING:
Do not plug in your
cleaner until you have
completely assembled it
per the above instructions
and are familiar with
all instructions and
operating procedures.
1. 2.
1.
3.
5.
4.
2.
IMPORTANT
ASSEMBLY INSTRUCTIONS
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Slide the upper handle onto
the body of the machine by
guiding the 2 posts on the
body into the opening on
the upper handle.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
under the support handle.
IMPORTANT
ASSEMBLY INSTRUCTIONS
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Slide the upper handle onto
the body of the machine by
guiding the 2 posts on the
body into the opening on
the upper handle.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
under the support handle.
IMPORTANT
ASSEMBLY INSTRUCTIONS
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Slide the upper handle onto
the body of the machine by
guiding the 2 posts on the
body into the opening on
the upper handle.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
under the support handle.
CORD
SIDE
HOSE
SIDE
Loading ...
Loading ...
Loading ...