Loading ...
Loading ...
Loading ...
Adjustthedeckrollerheightsothattheclevispins
areinsertedinthesecondhole(fromthetop)of
boththeleft-handdeckrollerbracketandtheright-
handdeckrollerbracket.SeeFigure5orreferto
DeckRollerHeightAdjustmenton page 9 for more
detailed instructionson adjusting the deck roller
upward or downward.
Notches
Fender
• Raise the deck lift arms up and out of the way by
placing the deck lift lever in the top notch on the
right fender.
• Gently slide the cutting deck beneath the tractor
from the right side.
• Move the cutting deck into position so that the
hooks found on the front end of the deck fit snugly
around the deck stabilizer rod.
Deck Lift Assembly
Lift Cables
Deck Lift Arms
Deck Idler Pulleys
Deck Support Pins
Belt Guard
Deck Roller Bracket
PTO / Deck Belt
Discharge Chute
Electric PTO Clutch
DeckStabilizer Bracket
NOTE: Many tractor components not shown for clarity.
Deck Stabilizer Rod
Front of Tractor
Figure 3
NOTE: The stabilizer rod may be secured to the tractor
frame with a plastic cable tie for shipping reasons. If so,
carefully cut the cable tie before mounting the front of
the cutting deck.
guards) and both idler pulleys as illustrated in
Figure 4 before proceeding.
• Relieve tension on the deck idler by inserting a 3/8"
drive ratchet wrench (set to "loosen") in the hole
found in the idler bracket and pivoting the wrench
handle counterclockwise. See Figure 4.
IMPORTANT: Be certain that the FLAT side of the PTO/
Deck belt is the side coming in contact with the deck
idler pulleys.
• With the tension relieved, carefully route the belt
around the electric PTO clutch.
• Lower the deck lift arms by placing the lift lever in
the bottom notch on the right fender.
• Pull the deck support pin (on the left side of the
deck) outward and align it with the hole on the rear
of the left deck lift arm before releasing the pin to
lock it in place as shown in Figure 5. Repeat on the
right side.
Installingthe PTO/OeckBelt
• Make certain that the PTO/Deck belt is routed
around the spindle pulleys (found beneath the belt
NOTE: If necessary, refer to the decal found on the
deck's surface or on page 19 of this manual for a
detailed belt-reuting diagram.
Loading ...
Loading ...
Loading ...