Loading ...
Loading ...
Loading ...
bladeorputtyknifebladewrappedinmasking
tape.Pryupbackedgeofhandlecapandremove
fromhandle.
• Removehandlefromdoorbyremovingtwo
mountingscrews.
• Remove2plugsfromoppositesideoffreezer
doorandreplaceinemptymountingholes.
cap
Plug
Freezer
handle
3. Removetophingecover.Tophingecoversnaps
off.Removetophingeandhingeshimusinghex
nutdriver.Removeandretainallshims.
4. Removerefrigeratordoorbyliftingdooroffof
centerhingepin.Inspectdoortoverifyallshims
arewithhingepin.
5. Removecenterhingepinusinghexnutdriver.Due
totightfitofpin,firmpressuremayneedtobe
applied.Removeandretainallshims.
6. Removefreezerdoorbyliftingdooroffbottom
hinge.
7. Removecenterhingebracketandhingeshim
usingPhillipsscrewdriver.
8. Removetoegrilleandbottomhingecover.Both
snapoff.
9. Removebottomhingeandhingeshimsusinghex
nutdriver.Removeandretainallshims.
5/16"_ H,t_
Tophinge screws Z___*--Hinge
_ shim(s)
5/16"
@*-- Roundshim
Rexnut _--_ . .
Center hingephillips/!_tnter_L_"_ *-centerh,nge hingeP'n
screws_ _ bracket &
shim(s)
@4-- Round shim(s)
B.ott°mT_--_K''_''_'_---- H n e
hinge pin __ shi_(s)
Bottom hinge _ ] I
10. Reverse door stops.
• Locate door stop at bottom edge of refrigerator
door. Unscrew two Phillips screws to remove door
stop. Remove the two Phillips screws on opposite
edge of door. Mount door stop on opposite side.
Replace remaining screws in empty mounting
holes.
• Repeat the above instructions to reverse door stop
on freezer door.
door
11. Reverse doors by performing the following steps:
• Remove plugs and screws in opposite side of
refrigerator cabinet. Insert in holes left from hinge
removal.
12. Mount bottom, center, and top hinges with shims
on opposite side of cabinet.
• Replace bottom hinge on opposite side of cabinet.
Verify hinge shims are in position before screwing
into place. After placing hinge pin into outside
hole, replace round shims. Some bottom hinges
may have plugs in holes. In case of this, remove
plug from outside hole, put pin in hole, and replace
plug in empty hole.
• Replace center hinge bracket and hinge shim, and
screw into place.
• Hang freezer door.
• Replace center hinge pin with hex nut driver. Make
sure fit is tight. Replace round shims.
• Replace top hinge and shims, but allow enough
clearance to slide hinge side of refrigerator door
into place. Tighten down top hinge to securely hold
door.
• Use a dime at top to space door W_e"(18 mm)
from cabinet.
• Handle side of door should be approximately
V_"(3 mm) higher than hinge side. Boor will
become level when it is loaded with food.
118"
(3 mm) --
mm)
II'1
m
Loading ...
Loading ...
Loading ...