Loading ...
Loading ...
Loading ...
NOTE:This unitis shippedwithoutgasolineor oil inthe engine.Be
certainto serviceenginewithgasolineandoil as instructedin the
Operationsectionof this manualbeforeoperatingyourmachine.
NOTE:Referenceto rightand lefthandsideof the Tilleris observed
fromthe operatingposition.
OPENING CARTON
1. Removeall staplesfromaroundthe bottomof the perimeter.
2. Removethe carton fromthe skid.
3. Removeall looseparts.
4. Removeloosepackingmaterial.
REMOVING UNIT FROM SKID
1. Thetiller is heavy,do notattemptto removeit from the skiduntil
instructedto do so in these assemblysteps.
2. Checkcarton thoroughlyfor anyotherlooseparts.
LOOSE PARTS IN CARTON
• HandlebarAssembly
• Tiller
• EngineOil
• Operator'sManual
ATTACHING THE HANDLE ASSEMBLY
1. Installthe handleontothetiller usingthe hardwarepre-installed
onthe handlemountingbrackets.Thisconsistsof a 5/16-18x
3.00"hex bolt,a handlecrankassembly,retainerbracketandtwo
5/16-18flangelocknuts. Removethishardwarefromthe handle
mountingbracketson the tiller.Referto Figure1 inset.
f -_,
3. Installthe handle-crankadjustmentrod intothe top holeof the
mountingbracketfromthe left handsideof the handleassembly,
securewiththe otherflangelock nut previouslyremoved.Fit
the hexend of the retainerbracketoverthe flangelocknut.See
Figure1.
4. Tightenthe hexbolt installedin Step2 atthis time.Be carefulnot
to overtightenthis hardware.
5. With the handlein the desiredposition,tightenthe handlecrank
adjustmentrodat thistime.
ATTACHING THE CABLES
1. Routethe two cables alongthe handleassemblyon the righthand
side.
2. Connectthe reversecable(Red)to the reversecablecontrolby
feedingthez-hookthroughthe holeon the reversecablecontrol
fromthe insidetowardstheoutside.SeeFigure2.
f ---
/
Figure2
3. Connecttheforwarddrivecable(Black) to the clutchbailby
feedingthez-hookthroughthe holeon the clutchbail fromthe
outsidetowardsthe inside. See Figure2.
NOTE:Testthefunctionof the reverseclutchby pullingthe reverse
handleand releasingit.The handleshouldreturnto its neutral
position.If it doesn't,contactCustomerSupportforassistanceorthe
nearestdealer.
Figure1
2. Insertthe handleintothe handlemountingbrackets,lining upthe
pre-drilledholes.Insertthe5/16-18x 3.00" hexbolt inthe bottom
holefromthe left handside throughto the otherside. Placethe
roundholeendof the hex retainerbracketoverthe hexbolt and
securelooselywitha bellwasherand5/16-18flangelocknut
removedearlier.Referto Figure1inset.
NOTE:Thebellwashershouldbepositionedwiththetopd thebellshape
towardsthehexnutwhichwillcreatetensionandfurthersecuretheflange
locknutoncetightened.Donottightenthis hardwareatthis time. 7
Loading ...
Loading ...
Loading ...