Loading ...
Loading ...
Loading ...
page 7
8. Canopy Assembly.
Loosen the screws in the 2 slotted holes in the LED
light kit (located on the underside of the motor
housing) and remove the other screw. Twist LED light
kit and pull down carefully in order to remove.
Note: Molex plugs must be disconnected before
removing the LED light kit from motor housing.
Molex plugs may be disconnected by simply pulling
them apart.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and break.
Locate 12 blade attachment screws and washers in
hardware pack. Slide a blade through one of the
narrow, rectangular openings on motor housing,
aligning holes in blade with holes in blade arm
(located inside of the underside of motor
housing)--refer to drawing at right. Insert 3 blade
attachment screws (along with washers) and tighten
screws securely with a Phillips screwdriver. Repeat
procedure for each remaining blade.
Note: Tighten blade arm screws twice a year.
9. Blade Assembly.
Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert
screws previously removed (on page 3, Section 4)
and secure all screws with a Phillips screwdriver.
blade
motor plate
molex
connections
LED light kit
motor
housing
blade attachment
screws and washers
screw
hanging bracket
canopy
Loading ...
Loading ...
Loading ...