WRF532SMHZ02 Owner's Manual

Loading ...

4. Lift up on the drawer front to release the plastic studs from the

drawer glide bracket slots as shown below.

Style 1 Style 2

A. Drawer glide bracket slots A. Drawer glide bracket slots

5. Slide the drawer glides back into the freezer.

Front Style 3

1. Open the freezer drawer to full extension.

2. Loosen the four screws attaching the drawer glides to the

drawer front as shown below.

NOTE: Loosen screws three to four turns. Keep the screws in the

drawer front.

A. Four Bracket screws

3. Lift drawer front upward and off the screws.

REPLACE DRAWER

Front Style 1 and 2

1. Pull out the freezer drawer glides to their full extension.

2. Holding the drawer front by its sides, align the two plastic

studs, located at the bottom, inside the drawer front, with the

drawer glide bracket slots.

NOTE: It helps if one person holds the drawer glides steady

while another person aligns the drawer front and inserts the

studs into the slots.

Style 1 Style 2

A. Drawer front screw A. Drawer front screw

B. Drawer front plastic stud

3. Replace and tighten the two screws at the top of the drawer

front (one on the left-hand side and one on the right-hand

side).

Front Style 3

1. Slide the drawer glides out of the freezer compartment.

2. Insert the screws in the top of the drawer into the slots in the

drawer brackets.

3. Completely tighten all four screws.

Door Closing and Alignment

The base grille covers the adjustable brake feet and roller

assemblies located at the bottom of the refrigerator below the

freezer drawer. Before making any adjustments, remove the base

grille and move the refrigerator to its final location.

Tools Needed: 1/4" hex driver Tools Provided: 1/8" hex key

1. Remove base grille.

BASE GRILLE

Style 1

� Using both hands, grasp the grille firmly and pull it toward you.

Open the freezer drawer to access the brake feet.

NOTE: To allow the refrigerator to roll easier, raise the brake

feet by turning them counterclockwise. The front rollers will be

touching the floor.

Loading ...

Owner's Manual - Page 24