Loading ...
Loading ...
Loading ...
7
INSTALLATION INSTRUCTIONS
Electrical connection
●●
This appliance must be supplied with a 220–240V, 50Hz, sinusoidal, 10Aelectrical
supply.
●●
Check the power cord for damage, making sure it is not squashed or twisted.
●●
A damaged power cord must be replaced by a Fisher & Paykel Authorised Repairer, in
order to avoid a hazard.
●●
The appliance must not be operated until it is repaired, as there is a risk of electric shock.
Draining
●●
Regularly check that your standpipe or tub is free from lint or other obstructions, which
may affect how your washer works or may cause flooding.
●●
In multi-storey apartments or any upper floor, the washer should be installed on a floor
equipped with a drain.
●●
Draining must comply with local by-laws.
Water supply
IMPORTANT!
Your cold water should not exceed 35°C and your hot water should not exceed
65°C. Temperatures above these may cause the washer to fault or cause damage
tothewasher.
●●
If you have an uncontrolled water heating source (eg a wet back or solar heating
system) you should fit a tempering valve. This will ensure the hot water temperature
remains within safe limits.
●●
Contact your registered plumber to select and install the tempering valve.
●●
Inlet water static pressure: Max.1MPa(150psi) Min.34KPa (5psi)
●●
Inlet water flow rate at tap: Min.6litres/min
IMPORTANT!
●●
This appliance must be installed in accordance with the installation instructions
before use.
●●
Provide accessibility to the plug or incorporate a switch in the fixed wiring in
accordance with the wiring rules to allow disconnection of the appliance from the
supply after installation.
●●
Do not operate this washer if it has been damaged during transport. Contact your
Fisher&Paykel dealer or Fisher&Paykel Authorised Repairer.
Loading ...
Loading ...
Loading ...