Loading ...
Loading ...
Loading ...
31
CHANGING PRE-SET OPTIONS
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out
of balance load is detected, the washer will stop and re-try spinning one more time. If it
still senses an unbalanced load there are two options the washer can take.
Automatic recovery OFF (the default setting)
Your washer will stop, beep, and show
in three phases on the display
screen. You must redistribute the load more evenly yourself. Use this option if you wish
to conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. It will fill with
water and agitate to redistribute the load before trying to spin up again.
To change the out of balance (OOB) recovery option:
1
Enter Option Adjustment mode (refer to page 28).
2
Select the ‘Delicate’ cycle.
3
Touch the ‘More’ button to turn automatic recovery or .
Wash Temp
OOB Recovery
EOC Beeps
Factory Reset
Changing the OOB routine
End of cycle beeps
The beeps signalling the end of the cycle can be increased or decreased. The default
setting is 5beeps.
To modify the number of beeps sounding at the end of the cycle:
1
Enter Option Adjustment mode (refer to page 28).
2
Select the ‘Wool’ cycle.
3
Touch the ‘More’
or ‘Less’ button to increase or decrease the number of beeps, or
for no beeps to sound at the end of the cycle.
OOB Recovery
EOC Beeps
Factory Reset
EOC Beeps
Wash Temp
Modifying the number of beeps to signal the end of the cycle
Remember, to save changes and exit from the Option Adjustment mode (ie to return to
normal operating mode), touch the ‘Power’ button.
Loading ...
Loading ...
Loading ...