Loading ...
Loading ...
Loading ...
Page 10
Electrical connections
To be certain that all of the air is out of the water heater, open the hot water faucet on your xtures until
constant water ows from them. If air remains in the tank, the element will be damaged when the electric
cord is plugged in.
Connect the water heater to a grounded outlet.
The water heater is tted with a power cord that is intended to plug into a grounded 110-120 V/AC
receptacle. Adhere to all pertinent State and local codes. Install the correct size circuit breaker into the
master panel. The Camplux Mini Tank water heater was manufactured and wired in accordance with UL
requirements.
The water heater is equipped with an overheat limiting device with a manual reset. Also known as the
temperature high limit, this device has been factory installed to interrupt the power supply in the event of a
thermostat failure. This water heater is designed for only 110-120V electrical service!
Do not connect to higher or lower voltage.
Failure to use proper voltage may result in personal injury and/or property damage. If the supplied
electrical power cord is either damaged or not long enough, do not use an extension cord. Have a
licensed electrician replace the power cord.
Instructions for use
Congratulations! You are now ready to use your water heater. Run the hot water at a nearby
sink and evaluate the hot water temperature. Make any temperature adjustment using the section
below:
Loading ...
Loading ...
Loading ...