Loading ...
Loading ...
Loading ...
8
© 2021 United States Stove Company
INSTALLATION
IMPORTANT:
INSTALLATION AND REPAIR SHOULD BE
DONE BY A QUALIFIED SERVICE PERSON.
THE APPLIANCE SHOULD BE INSPECTED
BEFORE USE AND AT LEAST ANNUALLY
BY A QUALIFIED SERVICE PERSON. MORE
FREQUENT CLEANING MAY BE REQUIRED
DUE TO EXCESSIVE LINT FROM CARPETING,
BEDDING MATERIAL, ETC. IT IS IMPERATIVE
THAT CONTROL COMPARTMENTS, BURNERS
AND CIRCULATING AIR PASSAGEWAYS OF
THE APPLIANCE BE KEPT CLEAN.
WARNING:
FAILURE TO POSITION THE PARTS IN
ACCORDANCE WITH THESE DIAGRAMS, OR
FAILURE TO USE ONLY PARTS SPECIFICALLY
APPROVED WITH THIS APPLIANCE MAY
RESULT IN PROPERTY DAMAGE OR PERSONAL
INJURY.
HARDWARE PACKET CONTENTS
KEY DESCRIPTION ITEM QTY
i Medium Screw 3
ii Large Screw 4
iii Washer 4
iv Spacer Washer 4
v
Rubber
Grommet
2
vi Small Screw 8
INSTALLING THE APPLIANCE
Separate the hanging bracket from the appliance
by removing two screws on the top and two nuts at
the bottom.
INSTALLING THE HANGING BRACKET
ON A NON-COMBUSTIBLE WALL ( I.E.,
MASONRY BLOCK OR CONCRETE)
1. Draw the position of the hole for the air-vent
intake pipe, taking into account the minimum
clearances mentioned in gure 4. See
dimensions of the square hole “D” and height
to the center “C” in table 1 and gure 5 for the
different models. Height “C” is the minimum
recommended.
TABLE 1
MODEL C D
DVAG 11N -
DVAG 11L
20-7/32” (514 mm)
11-1/4” X 11-1/4”
(286 x 286 mm)
square hole
DVAG 17N -
DVAG 17L
20” (508 mm)
DVAG 30N -
DVAG 30L
25-7/16” (647 mm)
2. Cut the square hole through the wall according
to the measurements and positions indicated
in gure 5.
C
FLOOR
D
D
Figure 5
Loading ...
Loading ...
Loading ...