Loading ...
Loading ...
Loading ...
EN
©2020 Hestan Commercial Corporation
16
INSTALLATION OF ANTI-TIP DEVICE
(CONTINUED)
ANTI-TIP BOLT ADJUSTMENTANTI-TIP BOLT ADJUSTMENT
After leveling the range, and after the bracket has been attached, adjust the anti-tip bolt and large
washer under the range so the top of the washer is 1-1/4” [3.2 cm] maximum from the floor. Slide
the range into the opening of the bracket and verify the bolt is engaged in the bracket as seen
below. Carefully tip the range forward to check. The range should not move more than 1” [2.5 cm].
ELECTRICAL CONNECTIONS
ELECTRICAL SHOCK HAZARDELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Before turning
power ON, be sure all controls are in the OFF position. Failure to do so can
result in electrical shock or death.
ELECTRICAL GROUNDINGELECTRICAL GROUNDING
This appliance must be grounded. Grounding reduces the risk of electric
shock in the event of a short circuit. Grounding through the neutral conductor is prohibited for
new branch circuit installations (1996 NEC), mobile homes, and recreational vehicles, or in an area
where local codes prohibit it. This range has been setup at the factory for a 4-wire connection.
CAUTION
Improper grounding will cause malfunctions in the unit, such as
continuous sparking of the igniters. This can damage the appliance and
create a shock hazard condition.
ELECTRICAL CONNECTIONELECTRICAL CONNECTION
The appliance may be connected using the cordset provided, or may be hard-wired. The appliance
must be on its own dedicated circuit - 240 VAC, Single Phase, 60 Hz, with a current rating as shown
in the model number listing on pg. 2. The installation must be done in accordance with local codes,
or in the absence of local codes, it must be installed in accordance with the National Electrical
Code, ANSI/NFPA 70.
For both US and CANADA installations: This appliance is equipped with
copper lead wires and must be connected to copper wires only. Improper
connection of aluminum house wiring can result in a fire or shock hazard.
Use only connectors designed and certified for connecting to aluminum
wire, and installed by a qualified electrician.
Loading ...
Loading ...
Loading ...