Loading ...
Loading ...
Loading ...
|nstallation
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!_ Your refrigerator should be positioned
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii[ito allow easy access to a counter when
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!iremoving food. Forbest useofdrawers and
freezer baskets, the refrigerator should be
in a position where both the refrigerator and
freezer doors can be fully opened.
Guidelines for final positioning of your
refrigerator:
o All four corners of the cabinet must rest
firmly on the floor.
The cabinet should be level at the front
and rear.
The sides should tilt 1Ainch (6 ram) from
front to back (to ensure that doors close
and seal properly).
Doors should align with each other and
be level.
All of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the doors using the adjustable
lower hinge (some models):
1 Before leveling either door, remove
set screw that locks door height into
position. (The door cannot be adjusted
without set screw removed).
2 If the refrigerator door is lower than
the freezer door, raise the refrigerator
door by turning the adjustment screw
clockwise using a 7/16 inch wrench.
(See illustration.)
3 If the freezer door is lower than the
refrigerator door, raise the freezer
door by turning the adjustment screw
clockwise using a 7/16 inch wrench.
(See illustration.)
Raise
Door__Door TA "
Door } Door
To level the cabinet using the front rollers:
1 Open both doors and remove the toe
grille (see "Toe Grille Installation and
Removal" in the "Installation" section).
2 Close the doors and use a flat-blade
screwdriver or _,t inch socket wrench to 4 After leveling, verify door stop contacts
raise or lower the front rollers, lower hinge and top of door does
not contact upper hinge through full
3 Ensure both doors are bind-free with movement of door (from fully closed to
their seals touching the cabinet on all fully open).
four sides.
5 Reinstall set screw, locking the door
Raise height.
Flange.._ _L-_.-
.... }J
\_ (( -Hinge
I _\ \\ r _1 set Screw
_ (some models)
'-- Hinge
7/16" Wrench and
3/32" Hex Key (some models)
6 Replace the toe grille by fitting it into
place (see "Toe Grille Installation and
NOTE: Level the unit with the adjustable Removal" in the "installation" section).
rollers before leveling the doors.
Loading ...
Loading ...
Loading ...