Loading ...
Loading ...
Loading ...
Connecting The Water Supply il
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
10.
If you use stainless steel tubing - The
nut and ferrule are already assembled on
the tubing. Slide compression nut onto
valve inlet and finger tighten compression
nut onto valve. Tighten another half turn
with a wrench; DO NOT over tighten.
See Figure 2. Steel
5. With steel clamp and screw, secure /" water line
water supply line (copper tubing only) to
rear panel of refrigerator as shown.
6. Coil excess water supply line (copper "Water Valve
tubing only), about 21/_turns, behind Bracket
refrigerator as shown and arrange coils
so they do not vibrate or wear against
any other surface.
7. Turn ON water supply at shutoff valve L
and tighten any connections that leak. -- Water Valve
8. Reconnect refrigerator to electrical power
source. 6 ft. Stainless Steel water line from
9. To turn ice maker on, lower wire signal household water supply
arm (side mounted) or set the ice
maker's On/Off power switch to the "1"
position (rear mounted).
Test system before use. Check for leaks
again after 24 hours.
Plastic Water
Maker Fill
Tube
p
ut
(Sleeve)
water line
Bracket
• Water Valve
)er water line
from household
(!nclude enough tubing in loop to allow
moving refrigerator out fOr cleaning:)
Figure 1
Plastic
np
Inlet
Figure 2
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
CCCCCCCCCCC:I
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!ill!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i
Loading ...
Loading ...
Loading ...