Loading ...
Loading ...
Loading ...
Icemaker is not Refrigerator was recently installed or
making ice. icemaker recently connected.
Icemaker not turned on.
The ice detecting sensor is obstructed.
The refrigerator is not connected to
a water supply or the supply shutoff
valve is not turned on.
Icemaker shutoff (arm or sensor)
obstructed.
Reverse osmosis water filtration
system is connected to your cold
water supply.
iCE & WATER
i!! iii i! i! i iii il il il il il il il il iiii_ ii_ _iiil i_ i_i ililili iiiii!_iiiiiiiiiii il il !i ! ii il il ili!i !i !i ii i ii iiiii iiill i
Solut o.s
it may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Locate the icemaker ON/OFF switch and confirm that
it is in the ON (I) position.
Foreign substances or frost on the ice-detecting sensor
can interrupt ice production. Make sure that the sensor
area is clean at all times for proper operation.
Connect the refrigerator to the water supply and turn
the water shutoff valve fully open.
If your icemaker is equipped with an ice shutoff arm,
make sure that the arm moves freely. If your icemaker
is equipped with the electronic ice shutoff: sensor,
make sure that there is a clear path between the two
sensors.
Reverse osmosis filtration systems can reduce the
water pressure below the minimum amount and result
in icemaker issues. (Refer to the Water Pressure
section.)
Not dispensing water. New installation or water line recently Dispense 2.5 gallons of water (flush for approximately
connected. 5 minutes) to remove trapped air and contaminants
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
dosed properly.
Water filter has been recently
removed or replaced.
Tubing connecting refrigerator to
house supply valve is kinked.
The house water supply is not
connected, the valve is not turned on
fully, or the valve is clogged.
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
Press and hold the Lock button for three seconds to
unlock the control panel and dispenser.
The dispenser can be set for ice or water. Make
certain that the control panel is set for the proper
operation. Press the Water button on the control panel
to dispense water.
Water will not dispense if any of the refrigerator
doors are left open.
After the water filter is replaced, dispense 2.5 gallons
of water (flush for approximately 5 minutes) to remove
trapped air and contaminants from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
The tubing can kink when the refrigerator is moved
during installation or cleaning resulting in reduced
water flow. Straighten or repair the water supply line
and arrange it to prevent future kinks.
Connect the refrigerator to the water supply and turn
the water shutoff valve fully open.
If the problem persists, it may be necessary to contact
a plumber.
45
Loading ...
Loading ...
Loading ...